Pump Starter Dealers in Lucknow

Specifications Waders AGRO-110 is a revolutionary device, designed to assist farmers in controlling their tube wells, by mobiles. Mobile Operated Tubewell Starter for Rural Areas – Model AGRO-110    Waders AGRO-110 is a revolutionary device, designed to assist farmers in controlling their tube wells, without going to the tube well starter, by means of a mobile phone.    AGRO-110 is a GSM Mobile based remote control system exclusively for the use with water pump sets in agriculture areas. The need of AGRO-110 came from the routine problems faced by the farmers in operating the pumps. They are, fluctuations in power supply, difficult terrain, fear of animals on the way to pumps, hazardous locations of the pumps along the river or water storage beds, shock hazards, rains etc. and most of all, high amount of physical labor and time.    Features of AGRO-110 Mobile Controlled Pump Starter :    • Water pump can be controlled from any distance by a mobile or land line phone. • A unique password dedicated to each pump set, to prevent unauthorized access. • One can check availability of the power supply at the pump end. • One can check the load on / off status by a simple audio tone. • Automatic Mode / Remote Mode Available. • Provision of memory for storing the on and off commands. • Last pump status is stored in memory in case of mains failure. • The pump is started automatically if pump was on before mains failure.   Functions of AGRO-110 Mobile Controlled Pump Starter :    AGRO-110 is connected to the pump starter, by easy connections. A farmer has to simply dial a number dedicated for the unit, and then punch his on or off code for the control of the pump set. It can be connected to any existing electrical starter and motor pumps. Hence, there is no necessity of replacing the pumping set. For higher capacity pumps, it can be connected along with protections against various faults.    Technical Specifications of AGRO-110 Mobile Controlled Pump Starter :  1. Unit Operating Voltage : 120-290 Volts, 50 Hz AC  2. Output : 5 Amp. potential free relay contact. 3. Input : [1] A unique password to prevent unauthorized access. [2] Different codes to start and stop the pump.             [3] If Mains supply is OK, the pump is started. Otherwise, user receives a Mains Error tone.             [4] User can check the status of the pump, any time by punching status code. 4. Indicators : Mains OK, Pump On 5. Battery Back-up : 12 Volts D.C