Waders Power Chowk, Lucknow, Uttar Pradesh

The GRD-110-MSG is a GSM based Fire Alarm/Monitor device, that sends and receives SMS. The GRD-110-MSG is state of the art Fire Alarm/Monitor device, based on microcontroller embedded technology, designed exclusively for Mobile BTS/Telecom Shelter or any other place, where fire alarm, is needed. The unit is completely programmable at the site. It has a user-friendly Man-machine interface with the help of a keypad, LED's and a LCD display. Since, all messages are displayed on a large size, LCD, the messages are in clear user friendly language. The  device  makes  use  of  GSM  network's Short  Message  Service  (SMS)  to  send system  status,  to predefined  mobile  numbers.    Features   1-4 Fire Zones can be wired with out any extra interface.   Temperature is set in range of 0-100 C.   Alarm on Smoke Detection or increase in temperature   Local audio visual alarm, in case of any alarm.   5-10  Mobile Numbers can be entered, to send  or  receive  messages.    If the alarm is not “Acknowledged”, within the given time, the message, determining the  current status, i.e. Site Id, Temperature, Smoke Detector Status, is sent to the group of authorized mobile numbers   Any individual authorized user can enquire the system status at any time. The system will send back a status message to that particular number only.   The  unit  is  powered by its own power supply, so that, the unit keeps working , when mains and generator  supplies  are  failed  in  extreme conditions 

Specifications Bell Management System is designed to ring the School & College Bell at programmed times. Peon-110 Automatic Bell Management System is a unique and elegant device, especially designed to ring the School & College Bell at programmed times, throughout the day. It is also useful for factories, offices, etc. Because of the intelligent automation, there is no need to assign an individual for ringing the bell, at different times during the day.

WADERS' POWER CONTROLLER UNIT (PCU) is a complete power management solution for mobile / telecom BTS shelters WADERS' POWER CONTROLLER UNIT (PCU) is a powerful and economical solution for mobile / telecom BTS shelters, providing complete power management. It comprises of Intelligent AMF controller for generator, Automatic Healthy Mains phase selector, load distribution panel, Mains Supply Regulator Unit, fault alarms and much more. Up to three BTS Batteries can be connected and monitored by the PCU. Generator running hours depend on the BTS Battery condition, hence, reducing overall running of genset, resulting in low maintenance and trouble free running for longer periods.   Key Modules of PCU • Monitors 3 Nos. BTS Batteries simultaneously • Intelligent AMF Controller Module • Auto Healthy Mains Phase selector • Mains Supply Regulator/Conditioner Unit • Surge Protection Devices. • Monitoring various parameters of Mains and DG. • Bargraph Display for BUS, Load and DG Battery • Status Display for every stage of operation • Alarms & Potential free contacts for various faults • Real time clock and event recording facility • Logbook for DG running sessions • Logbook for various Faults occurrence during operation • Fire Alarm Module • 10 Smoke Detectors in 2 zones can be installed • Aviation Lamp Controller • AC Distribution unit • SMPS Charger for DG Battery • Air Conditioner Controller (Optional) • 2 level fuel alarms • Running Hours Recorder for DG • Room Temperature Monitoring Unit • Rs232 port for data transfer and logging

Specifications Waders AGRO-110 is a revolutionary device, designed to assist farmers in controlling their tube wells, by mobiles. Mobile Operated Tubewell Starter for Rural Areas – Model AGRO-110    Waders AGRO-110 is a revolutionary device, designed to assist farmers in controlling their tube wells, without going to the tube well starter, by means of a mobile phone.    AGRO-110 is a GSM Mobile based remote control system exclusively for the use with water pump sets in agriculture areas. The need of AGRO-110 came from the routine problems faced by the farmers in operating the pumps. They are, fluctuations in power supply, difficult terrain, fear of animals on the way to pumps, hazardous locations of the pumps along the river or water storage beds, shock hazards, rains etc. and most of all, high amount of physical labor and time.    Features of AGRO-110 Mobile Controlled Pump Starter :    • Water pump can be controlled from any distance by a mobile or land line phone. • A unique password dedicated to each pump set, to prevent unauthorized access. • One can check availability of the power supply at the pump end. • One can check the load on / off status by a simple audio tone. • Automatic Mode / Remote Mode Available. • Provision of memory for storing the on and off commands. • Last pump status is stored in memory in case of mains failure. • The pump is started automatically if pump was on before mains failure.   Functions of AGRO-110 Mobile Controlled Pump Starter :    AGRO-110 is connected to the pump starter, by easy connections. A farmer has to simply dial a number dedicated for the unit, and then punch his on or off code for the control of the pump set. It can be connected to any existing electrical starter and motor pumps. Hence, there is no necessity of replacing the pumping set. For higher capacity pumps, it can be connected along with protections against various faults.    Technical Specifications of AGRO-110 Mobile Controlled Pump Starter :  1. Unit Operating Voltage : 120-290 Volts, 50 Hz AC  2. Output : 5 Amp. potential free relay contact. 3. Input : [1] A unique password to prevent unauthorized access. [2] Different codes to start and stop the pump.             [3] If Mains supply is OK, the pump is started. Otherwise, user receives a Mains Error tone.             [4] User can check the status of the pump, any time by punching status code. 4. Indicators : Mains OK, Pump On 5. Battery Back-up : 12 Volts D.C

Specifications An ideal and economical solution to control single/three phase Submersible Pumps. Waders presents the microcomputer based Automatic Water Level Controller, the ultimate water filling system, to take care of daily task of water filling. It is available in 8 models to cover full range of water pumps from domestic pumps to giant 3 phase water pumps. The water pump is plugged into the system and pump is automatically switched ON and OFF, when required. Automatic Water Level Controller can be used to remove used water from the storage tanks, automatically.   Features At A Glance The foremost purpose of the system is to make the user free of all his daily water filling requirements. All the operational states are displayed digitally through 7 segment display. Easy to control auto and manual mode. It monitors low and high level in the tank. The pump is switched ON, when water level goes below low level. And pump is switched OFF, when tank gets full. So that, there is no chance of dry running or over flowing. It can also be used in dual tank systems, when it is required to monitor the ground tank as well as the over head tank. It can also be used to remove water from the storage tanks. Models available from any single or three phase pump With the help of two sensors, it keeps an eye on the inlet water supply as well as over head tank. As soon as it senses water at the inlet, pump is switched ON. So the user does not have to worry about the arrival of the water supply. So the whole process is completely automatic, Waders Automatic Water Level Controller helps in saving water and electricity, as well as it reduces the trouble of daily water filling process.

Max. Voltage : 280VAC

Specifications HJ110 series AMF controllers provide generator and mains changeover in AMF control panels, along with AMF features.. HJ110  series  AMF  controllers  are  designed  to  control  the  Standard  AMF logic, prevalent in the  power  generation  industry.  Because of its compact and powerful design, external wiring and components are reduced to the minimum, which enhances the overall performance of the AMF panels. Basic  functions  of  Hj110  SP  and  HJ110  TP,  are  same,  except that HJ110 SP is meant for the single phase generators and HJ110 TP has necessary operational differences related to three phase generators. We also have BT110 series AMF CONTROLLERS, which are powerful and dedicated AMF controllers for Mobile / Telecom BTS Shelters, providing complete power management.  It comprises of Intelligent AMF controller for generator, Mains Supply Monitor, shelter Battery Monitor, Remote Fault alarms and much more. Exclusive shelter battery monitoring avoids unnecessary running of generator. Generator running hours depend on the BTS Battery condition, hence, reducing overall running of generator, resulting in low maintenance and trouble free running for longer periods.   Features of HJ110 Series AMF Controllers Displays Load On Mains/Gen, Voltage, Current, KVA, Frequency and Generator RPM Displays individual AMF timers in progress, in countdown mode Different messages related to Engine and Electrical faults are also available for the user Built in Line Voltage Monitor (LVM) to ensure safety of electrical load connected to panel Built in Genset Voltage Monitor, for the safety of generator and connected load Built in timers for : Mains Wait Time, Cranking Wait, Cranking ON, Cranking OFF, Cranking Attempts, Stop Solenoid, Engine Idle Run, and are programmable at site Built in Engine Safety for Low Oil pressure, High Coolant temperature and Start failure (Fail To Start) Other inputs(on request): Low fuel level alarm, Emergency Stop, Fail to Stop Alarm, etc Mode of operation: OFF, Auto, Manual and Program Auxiliary contacts for Mains Contactor, Alternator Contactor, Start, Stop, Fail to Start, etc Programmable parameters for Mains Wait Timer, Generator Wait Timer, Crank Wait Timer, Crank On Timer, Crank Off Timer, Crank Attempts, Stop Solenoid Timer, Idle Run Timer, Mains Over/Under Voltage, Generator Over/Under Voltage, Voltage Trip Time, CT rating Password protection to prevent unauthorized access to program menu

Specifications Load is turned On/OFF, according to the Sunrise/Sunset timings of the location, for 365 days of the year A True Nature Switch, in real sense. An ultimate product for Energy Conservation. Load is turned On/OFF, according to the Sunrise/Sunset timings of the location, for 365 days of the year.  No need of maintenance, as in photo sensor based or infrared sensor based devices. No need to adjust time in 15/20 days as in time switches. A True Nature Switch, for complete unmanned operation Optional Manual Override This switch is an ideal time switch for switching on street lights, high mast lights, compound lights in housing societies, advertisement hoarding lights, sign board lights at sunset time & switching off at sunrise time without any light sensor. Twilight Option is also available and adjustable between 0-60 mins. Lights are activated when needed, hence : - reduces electricity consumption, - enhances luminaries' life. Multiple Circuits can be controlled to reduce load in late night.(available in Model ESO110 series Energy Saver) An ideal Energy Saver for Municipal and City Corporations for street lights, Industries, Housing Societies, etc. SAVES up to 30% Electricity Daily.