Dust Monitoring System Dealers in Ludhiana (1 products available)

A Dust particulate monitor is a device that is mounted in the discharge stack of a dust collector and continuously monitors the amount of particulate discharge. The particulate monitor uses a technology known as Triboelectric or Triboelectricity. When two different materials come in contact, it is likely that one will leave with more electrons than it started with and the other will leave with less, this is called Triboelectric Effect. The interaction between the probe and particles produces a charge transfer within the probe. The charge is then converted to an output signal.Dust Particulate Monitoring systems TECHNICAL SPECIFICATION Measuring Principle Dynamic Detection Principle, DDP (Scintillation) Operating Wavelength 510 – 540 nm (green LED)Measurement Reading Concentration (mg/m3)Measuring Range 0 – 1000 mg/m3 (user configurable)Path Length (duct diameter) 0.5 – 10 m (flange-to-flange separation)Accuracy + / - 2 %Flue gas flow rate ! 1.0 m/sResolution 0.1 mg/m3 (display resolution)Damping 1 – 60 s (user selectable)Drift with Temperature < +/- 0.5 %.POWER AIR REQUIREMENTS Voltage +24 Vdc (optional 90-260 Vac PSU available)Nominal Current Consumption 400 mAPower Up Current Consumption 400 mAPurge Air Supply Volume 50 – 200 L/min (to each air purge body)Purge Air Quality Suitably filtered, oil free and dryINTERFACE OPTIONS Serial Comms ModBus RTU via RS485Internal USB (OI)External USB (RX)Analogue Outputs 4.0 – 20 mA (isolated and scalable)Relay Contacts 3 A @ 30 Vdc (signal level and service alarms)PHYSICAL​Ambient Operating Temperature -20 – +55 °C (air temperature around the equipment)Exhaust Gas Temperature Up to +600 °C (heat insulating gaskets included)Ambient Operating Humidity 0 – 100 %Ingress Protection IP65 for external useMaterials 316 Stainless Steel (powder coated)Dimensions 153 x 120 x 122 mm (measuring head)Weight 2.5 kg per head  Specification :Range 0-1000 Mg/M3Sensor Base Systems StyleIntegral & RemoteRemote Sensor Enclosure: Cost Aluminum, Electrostatically powder coatingProbe Material: 316 Stainless Steel (Slandered) other materials availableInsulator material: Extended High Performance (PFA) Temperature up to 250 C Ceramic (High temperature up to 550 Deg C )Electronics 18 – 32 V DC () at the unit 230V AC (Controller)Output: 4-20mA & SPDT RelayProbe Insertion length: 3” to 36” ( 7.6 Cm to 91.4 Cm)Installation Weld the supplied fitting into the pipe or Duct and insert Sensor Sensor Mounting Flanged ½” Male NPT Quick release.