Air Valve Dealers in Bhandup East, Mumbai

The D-43 series Combination Air Valve has the features of both an air release valve and an air & vacuum valve. The air release component is designed to automatically release small pockets of air to the atmosphere as they accumulate along a pipeline or piping system when it is full and operating under pressure. The air & vacuum component is designed to automatically discharge or admit large volumes of air during the filling or draining of a pipeline or piping system. This valve will open to relieve negative pressures whenever water column separation occurs. Applications Pump stations: after the pump and after the check valve. Downstream (after) and upstream (before) of shut-off valves. After deep-well pumps. On long constant-sloped pipeline segments. At peaks along the pipeline and at peaks relative to hydraulic gradient. At end lines.

Protects from water hammer effects in the pipeline system ,in situations such as column seperation ,deep well pumping and rapid filling of mains Operation in deep well pumping In deep well, the long suction pipe in the well shaft is full of air .As water is pumped rapidly up the suction pipe, air is forced through the pump air valve in great velocity .If the air valve were to slim shut suddenly ,by the approaching water ,instantly reducing velocity to 0, it could cause a sever water hammer or surge .

Air disc valveAir disc valveAir disc valveAir disc valveCOSMOS” Non‐return Pressure relief Gravity Back draft dampers have been specifically designed for use in Air‐conditioning and Ventilation system, these dampers are air operated and are used for air intake and exhaust, and are also used for pressure relief. Non‐return Gravity Back draft dampers can either be operated by gravity (where pressure or velocity opens and closes the damper) or be motorized to open and close when required. These dampers are composed of a set of horizontally mounted blades, they are normally closed and are free to rotate about the horizontal axis. The blades are manufactured from light weight aluminum sheets. Frame is manufactured from high quality aluminum as well as from galvanized steel.

• RANGE: 0.1 to 0.3 mm.

Rotary Airlock Valve (RAV) is the equipment which is fitted below the Bag Filter, Cyclone, Multicyclone etc. The main function of the RAV is to lock the air and discharge the dust powder. In the Bag Filter system there is negative pressure in the Bag Filter. So at the powder discharge point if there is any air leakage the powder will not fall down. So to restrict the leakage we provide the Rotary Airlock Valve. RAV consists of a stator & rotor. The radial & axial clearance is between 0.1 to 0.3 mm. The rotor has vanes (6 or 8) welded on the shaft. The rotor is mounted on the bearings at both the ends of the stator. A Geared Motor is provided to rotate the rotor. Since the clearance between rotor & stator is so low. Because of this air leak is very minimum and it delivers only powder.

Our air release valves are, carefully designed by the experts, keeping the varied requirements of the clients. We can also customize these air release valves as per the definite requirements of our clients. features : easily disassembled forcleaningreplacing internal partslightweight for easy transport & installationself-cleaninggreater air flow ratesdurablepatented float designmechanism of a rolling sealrequire less maintenance widely used in : parking placesgo-downs and warehousesofficial buildingslifts and elevatorsresidential building

Fluid:Air Water Gas Steam Oil Thermic Fluid Hot Water Super Hot Steam Corrosive Non-Corrosive, any other fluid compatible with the material.Accessories:1) Filter Regulator with Gauge ,2) Limit Switch (Weatherproof Flameproof),3) 32 way solenoid valve,4) I to P converter,5) Valve position Transmitter,7) Top Side Hand wheel.

The D-070 Combination Dynamic Air Valve is a unique valve operating without a float, utilizing the rolling diaphragm principle.

• Material: CRC
• Brand Name: Aircons
• Surface Finish: Epoxy Powder Coated
• Shape: Round
• Available SIze: 4 to 8 inch

Air Dryers : A Compressed air system equipped with an adequate aftercooler, removes approximately twothirds of the moisture. That remaining one-third washes away all your efforts. It is always wise to size a dryer to your maximum requirements, and perhaps include some extra capacity for potential expansion of your pneumatic operations. Nowadays on site plumbing has become so costly that future expansion of compressed air use should be considered. For economy of operation it should be noted that the larger the dryer, the lower the cost of drying per CFM.

air line valves, Air Compressor, Air Cylinders, Air Dryer, Control Valves

Air Valve, Brass foot valves