Air Valve Dealers in Mulund East, Mumbai

The D-070 Combination Dynamic Air Valve is a unique valve operating without a float, utilizing the rolling diaphragm principle.

• RANGE: 0.1 to 0.3 mm.

Rotary Airlock Valve (RAV) is the equipment which is fitted below the Bag Filter, Cyclone, Multicyclone etc. The main function of the RAV is to lock the air and discharge the dust powder. In the Bag Filter system there is negative pressure in the Bag Filter. So at the powder discharge point if there is any air leakage the powder will not fall down. So to restrict the leakage we provide the Rotary Airlock Valve. RAV consists of a stator & rotor. The radial & axial clearance is between 0.1 to 0.3 mm. The rotor has vanes (6 or 8) welded on the shaft. The rotor is mounted on the bearings at both the ends of the stator. A Geared Motor is provided to rotate the rotor. Since the clearance between rotor & stator is so low. Because of this air leak is very minimum and it delivers only powder.

Our air release valves are, carefully designed by the experts, keeping the varied requirements of the clients. We can also customize these air release valves as per the definite requirements of our clients. features : easily disassembled forcleaningreplacing internal partslightweight for easy transport & installationself-cleaninggreater air flow ratesdurablepatented float designmechanism of a rolling sealrequire less maintenance widely used in : parking placesgo-downs and warehousesofficial buildingslifts and elevatorsresidential building

The D-070 Combination Dynamic Air Valve is a unique valve operating without a float, utilizing the rolling diaphragm principle. This unique structure allows the dynamic valves to discharge air from the water system in a controlled and gradual manner, preventing slam and local up-surges. When vacuum occurs , the valves fast reaction will draw in large volumes of air into the water system, impeding down-surges and, consequently, all pressure surges in the line. The valves are normally closed when the line is not operating, thus preventing the infiltration of foreign particles and insects into the water system. Applications Pumping stations, deep wells, and distribution lines. Systems that suffer from slam and local and system surges. Sites that require a combination of means to reduce water hammer or surges. Sites that require an air valve with a low profile due to lack of space.

Air Dryers : A Compressed air system equipped with an adequate aftercooler, removes approximately twothirds of the moisture. That remaining one-third washes away all your efforts. It is always wise to size a dryer to your maximum requirements, and perhaps include some extra capacity for potential expansion of your pneumatic operations. Nowadays on site plumbing has become so costly that future expansion of compressed air use should be considered. For economy of operation it should be noted that the larger the dryer, the lower the cost of drying per CFM.

The D-43 series Combination Air Valve has the features of both an air release valve and an air & vacuum valve. The air release component is designed to automatically release small pockets of air to the atmosphere as they accumulate along a pipeline or piping system when it is full and operating under pressure. The air & vacuum component is designed to automatically discharge or admit large volumes of air during the filling or draining of a pipeline or piping system. This valve will open to relieve negative pressures whenever water column separation occurs. Applications Pump stations: after the pump and after the check valve. Downstream (after) and upstream (before) of shut-off valves. After deep-well pumps. On long constant-sloped pipeline segments. At peaks along the pipeline and at peaks relative to hydraulic gradient. At end lines.

• Material: CRC
• Brand Name: Aircons
• Surface Finish: Epoxy Powder Coated
• Shape: Round
• Available SIze: 4 to 8 inch

air line valves, Air Compressor, Air Cylinders, Control Valves

Brass foot valves