Elevator Sensor Dealers in Andheri East, Mumbai

• Output: 0 - 2 Volts
• Material: Metal
• Weight: 60 Grams (g)
• Product Type: AC DC Current Sensor
• Usage: commercial

• Output: 0 - 2 Volts (Nominal) at full rated current
• Rated Current: 100 Amps max
• Operating Temperature: -40 C to 85 Deg C
• Zero Current Offset: +/- 0.5 mA at zero input current
• Linear Range: 0 - 150 Amps.
• Operating Voltage: 12 V DC
• Size: 47mm,41mm,13mm(LxHxW),ID=12.5mm
• Insulation Resistance: 500 Meg Ohm min at 500 V DC
• Weight: 600 gm
• Sensed Current Type: DC
• Application: Industrial,commercial and communications systems
• Linearity of Output: Within +/- 1% of full scale input current

The VPLog-i measures AC currents up to 3200A (true-RMS on a single phase power cable). The VPLog-i is very easy to use: just wrap around one of the three phases and close the snap fitting. It offers the best solution for your mobile power measurements. The VPLog-i is the only sensor on the market that offers both 4 ... 20mA and pulse outputs. Easy and simple: Just open the power meter and wrap around the power cable you want to measure. The LED on the device blinks when the VPLog-i is powered. The rate at which it blinks is proportional to the output current. You can use one of the two outputs to get accurate power measurement results. Power Meter Features/ Benefits Very easy and quick installation Plug and play For fixed and mobiel measurements Both 4 … 20 mA and pulse output Applications Power consumption of compressors General purpose power measurements Electricity sub metering

Non-intrusive "Clamp-On" current sensor “Clamp-on” or “Cable clamp” Current Sensors are sensors that are used for measuring AC or DC currents. They are particularly useful for measuring currents flowing in a cable wire in a non-intrusive way. Product Description The “clamp-on” current sensors are particularly useful for easy and safe installation. They are installed straightforwardly onto a wire going into the electrical load without the need to do any high voltage electrical work. The current sensor consists of a Melexis Hall Sensor (MLX91208) and a patented ferromagnetic structure packaged in a robust plastic housing. This non-invasive current sensor (also known as a “split core” or “cable-clamp” ) can be clamped around the supply line of any electrical load to tell you how much current is passing through it. It monitors the magnetic field around a current-carrying conductor and outputs a voltage proportional to the current. The clamp-on current sensors measure loads from +/-5 Amps to +/-230 Amps which makes it great for building your own energy monitor to keep your power usage down, or even building an over-current protection device for an AC load. Magnetic Characteristics AC and DC current measuring Motor control, over-current protection or DC Battery current monitoring Solar power junction boxes, smart junction boxes, lighting equipment, air compressor, water pumps E-mobility, charging stations, power management, state-of-charge

• ZERO CURRENT OFFSET: : +/- 0.5 mA
• LINEARITY OF OUTPUT: : WITHIN +/- 1% OF

Current sensor use resistive shunt or AC Current transformer. These two methods have limitations and disadvantages.Systems new Current Sensor uses Hall effect to sense AC or DC Current. The sensor is totally isolated from main Current and not susceptible to external disturbances.

Threaded & Flatpack Reed Sensors

Industrial Encoder, boiler automation, industrial robots