Heater Plate Dealers in Mumbai

Ceramic Heater Plate are so called because they have a number of ceramic plates attached to some coils of metal that heat up in the same way as a coil heater, but the plates absorb the heat and release it into the air. They are quicker than coil heaters and they take less time to cool down once they are switched off.

• Thickness: 5mm
• Length: 180mm
• Power: 200W
• Rated Voltage: 220V

• Model: HV-EXP4242

CIRCULAR PLATE HEATER Cast iron plate heater with built–in heating resistance. Aluminium body oven coated with acid proof epoxy paint. Front panel provided with ON / OFF switch and green LED and with a knob for adjusting and controlling a bimetallic thermostat on a graduated scale, with the relevant warning light indicating that the plate is working. N.B

Heater plate is equipped with uniquely designed & heavy duty heaters with PID temperature controllers with 3-phase solid state relays mounted in easily replaceable PC boards. USING THE HEATER PLATE The Heater plate of Hot Foil Attachment is manufactured from a specially developed graded casting and machined upto a highest accuracy. It has tapped (M6) holes over it's surface. The thickness of the heater plate is 17.5 mm. So it is possible to use a stamping dye of the image height 6.5 mm (max) on the heater plate. If one desires to use a thin dye (image height of 1.5 mm approximately), it is required to paste the same thin dye on an aluminium plate of 4 to 5 mm thickness. Some strong rubber solution or any other adhesive. A full size aluminium plate may also be permanently fixed on the heater plate. HOLDING & MOVING THE DYE To hold and move the dye for getting proper registration, different clamps are provided. To use calmp no.1, which gives much firm hold, it is essential to reduce the dye thickness at the borders by around 2.5 mm.  Clamp no.2 gives a lesser firm hold on the dye but it is more easy to use. It does not require any reworking of the dye. Movement of the dye is quite easy and a very minute adjustment is also possible with these clamps. PRECAUTIONS The operator has to be very cautious while fixing the dye on the heater plate. While mounting the clamps, never use invalid screws of longer length. This will damage the heater element placed inside the heater plate. It may also lead to a serious short circuit and the unit may get damaged. Never leave any screws loose. Use only the holes provided by the manufacturers. Creating additional holes for covering more printable area is risky. It may lead to serious accidents and damage to the machine. USEFUL TIPS A 100% firm contact between the surface of the heater plate and bottom of the stamping dye (or the aluminium plate beneath it) is extremely essential. Any gap may result to non-conduction of the heat. Selection of proper foil, make-ready material and make-ready technique and properly mounted dye of the best quality are the proven keys of getting good stamping results. Excessive temperature and pressure would never help to produce better results. One has to develop his own make-ready methods and choice of material for achieving more and more improvement.

We are offering foil stamping heater plate. Foil stamping heater plate made of imported aluminium specially graded to ensure even surface, equal, and rapid heat distribution and adequate compressive strength. Heater plates are equipped with uniquely designed heavy duty heaters with pid temperature controllers coupled with 3 phase solid state relays mounted in easily replaceable pc boards.

Heater Plate, Porcelain Ceramic Connectors, diesel glow plugs, heater parts