Hydraulic Compressor Dealers in Mumbai

CNG booster compressors& associated accessories including electrical panel, radiator, air compressor etc. These CNG booster compressors are equipped with programmable logic controller (PLC) and shall be SCADA compatible. Suction Pressure: 200 to 30 bar (G) Discharge Pressure: 250 bar (G) Average flow capacity: 500 SCMH Suction Temperature: Nominal 35ºC, Max. 45ºC Discharge Temperature: Max 8ºC above ambient Ambient Temperature: 48ºC Maximum        Medium: Natural Gas, Dry, SG – 0.58 to 0.65 Type: Hydraulic operated cylinders Configuration: Multi stage double acting Lubrication: Non lubricated Valves: Suction & Delivery Valves Gas meter: Mass flow meter based on Coriolis principle Driver: Electric Motor Drive: Hydraulic Motor :(i)Main Motor (ii)Water Pump (iii)Radiator (iv)Air Compressor (v) Exhaust fan Cooling: Water cooling to Gas Heat Exchanger Tube in Tube type Control Panel: Starter and Control Panel with Star/ Delta starter    Controls: PLC Control, Auto Start / Stop ON PR. Setting Manual Draining Instrumentation: PR. / TEMP. TRIPS, Gas leakage and fire trips Vessels: Discharge Pulsation Dampner Packaging: Complete Compressor Unit Fabricated on a Single Skid to make a Single operating unit considering ease of maintenance Priority panel: 2-bank Configuration priority provided Gas Detector & Flame Detector provided of approved makes Door interlocked isolator Panel complete with start and stop push buttons, hours run meter, power on and fault indication lamps, and fault reset button and HMI (Siemens / Schneider make). All necessary timers and intrinsically safe relays to control the system on an automatic starting and stopping basis All the interlock, monitoring and controlling of the CNG compressor package is done through PLC based control system of proven type and the Make of the PLC is Siemens(S7 300),  Schneider M340 PLC and Allen Bradley (Micrologix 1200) of latest version  or equivalent  PLC is housed inside flameproof IIA/IIB (Ex’d’) enclosure. Local operator panel is provided on the flameproof enclosure. The operator panel is provided for parameterization, indication, monitoring, and alarms and first out sequence of the system. PLC system have memory modules for storing user programs, symbol lists, Program comments and should facilitate debugging / trouble shooting without the application program. Program is ladder logic and communication is in English for each run. The Protocol and the other details for Interfacing is specified clearly. The Communication protocol is an open protocol i.e. MODBUS RTU Protocol for communicating with slave devices. Power supply to PLC supply is 24 VDC. The PLC has an Industrial Ethernet Module with min TWO Ethernet port and Modbus RS-485 (2-wire) port, Configured and programmed, to establish remote communication of PLC with the SCADA server.