Industrial Control Panel Dealers in Dombivali East, Mumbai

APFC or Automatic Power Factor Control Panels are mainly used for the improvement of Power Factor. Power Factor can be explained as ratio of active power to apparent power and it is a key factor in measuring electrical consumption. Everyone knows that how costly electricity has become in present time. Therefore it becomes utmost important to cut down on electrical consumption for reducing expenditure. FEATURE   Phase failure / loss from supply and motor side. Phase reversal / wrong phase sequence from supply side. Phase to phase current unbalance 50 % of set current. Electronic overload. Remote sensing dry run / No load current. Extreme high current (EHC) or short circuit as per pump current. APPLICATION The speed of a star-delta, squirrel cage induction motor depends on the number of poles of the motor and the supply line frequency (hertz). That is, the inrush and line current in the star connection are one-third the values of these quantities in the delta connection. Starting on the higher current delta connection would bump the voltage and create line disturbances.

We do the logic design as per users specific requirement and supply the Control Panel ready to work. It may even PLC based control. * MS powder coated panel * Uses quality component * Panel Design approval * Supply as per users need * Multi control system * Flame Proof Pane

shearing machine panel cum control desk, Electric Control Panels

We are positioned among the major Capacitor Panel Manufacturers, Suppliers and Exporters from India. In the Capacitor Panels the Auto power factor correction of loads takes place by centralized means. The total power of each piece of equipment is divided in several banks managed by an APFC relay. The latter is sensitive to variations in reactive power and connects or disconnects the banks maintaining the PF of the system at desired value. Salient Features : Auto/manual selection of banks with indicationForced air cooling of banks with axial flow fansThe range of power goes from 25 KVAR to 1000 KVARTripping with audio visual indication under high voltageHigh temperature, harmonic over load, and low PF condition Construction : Floor mounted and is designed to be used where medium high power is required. Mach smart energy analyzer is filled to check the capacitor current voltage for each phase separately, plus all value added features of Mach Smart. RS 232 serial port is provided on the panel to connect it to PC or hand held terminal for data logging.The unit is equipped with FSU at the beginning of the power supply.Earth fault protection is provided to disconnect the banks in case of fault.The cabinet has IP-30 protection with gray RAL 7035 structure with powder coated finish. Busbars are tinned electrolytic copper with 50 kA breaking capacity.

Automation Products, PLC Drives, scada systems

Industrial Control Panels, Temperature Controller, Timers, Counters