SUDHARSHAN ENGINEERING WORKS Jogeshwari, Mumbai, Maharashtra

("T" port & "L" port) size 15mm to 100 mm Suitable to use in Duplex Strainer and flow control in desired direction. M.O.C. : SS304, SS316, WCB

  (Size 15mm To 300mm Screwed & Flanged ASA 150 Class) : These valves are designed for least possible obstruction to free flow by providing curvature turns in the body. There by minimizing stresses & turbulences also. Discs are plug type and held together with stem by disc nut & allows the perfect seating arrangement on the seat. Carbon steel & cast Iron valves have renewable seats while stainless and other higher grade materials have integral seats. All the valves have back seat arrangement as an additional sealing under full working pressure which facilitates replacement of packing with the valve under fully open condition.

These valves are designed to provide minimum turbulence & resistance to flow when in fully open position. Sufficiently long guide ribs in the body along with accurately machined wedge guide slots ensure accurate control & alignment of wedge while operating wedges are generally solid type & are accurately machined, precisely aligned & perfectly lapped with renewable seats in carbon steel & integral seats in stainless steel. All the valves have back seat arrangement as an additional sealing under full working pressure which facilitates replacement of packing with valve under fully open condition.

(Size 25mm to 200mm ) Flush Ball Valves are of Soft Seated Floating Ball. One of the the most important component in any Ball valves is the Ball itself. The Ball is accurately machined to mirror finish and the exact sphericity so as to ensure low operating forque and high pressure holding capacity and thus increasing life of the valve. M.O.C. : SS304, SS 316, WCB

"SEW" Ball valves are of soft seated, Floating Ball. Three piece design available in both regular port & full port patterns. Ball is seat supported and quarter turn rotates the ball from full open to full close position. The Stem Flange, on entire part of the stem, prevents the stem from blowing out pressure within the body cavity. This feature also allows replacement of stem packing while the valve is under pressure. One of the most important component in any Ball valve is the Ball itself. The Ball is accurately machined to mirror finish and the exact sphericity so as to ensure low operating forque and high pressure holding capacity and thus increasing life the valve.