Surge Protection Device Dealers in Bhandup West, Mumbai

• Material: Brass
• Poles Number: 1 Pole
• Product Diameter: 2-3 Inch
• Product Length: 4-5 Inch
• Voltage: 230 V

Features       Excellent protective characteristics       High Durability       High Energy Handling Capabilit       Excellent Insulation Property       Excellent Temporary Overvoltage Capability       Light in weight.       Easy to handle.       No air column, hence no explosion.       Can be provided with disconnector, to run the system without nterruption to the power supply, in the existence of short circuiting the Surge Arrester.          

• Model SP2S1 for serial RS232: 2-wire Tx, Rx.
• Model SP2S2 for serial RS232: 4 wire Tx, Rx, DTR, DSR.
• Model SP2S3 for serial RS232: 7 wire Tx, Rx, RTS, CTS, DTR, DSR, CD
• Model SP2S4 for serial RS422 / RS485: 4 wire i.e. +Tx, --Tx, +Rx, -Rx.
• MLSP-2S for parallel port: Centronics/Bitronics Size:60 mm X 70 mm X 12 mm

Parallel / Serial (RS232C) / RS422 / RS485] Protect your parallel / RS232C / RS422C / RS485 data lines from unexpected surges and ground spikes.   Transient over voltages can be caused by lightning, coupling from power-line surges and induction from nearby loads such as motors or factory equipments. Data lines that runs near power, control or telephone cables are subject to short duration pulses of which could reach several thousand volts. The DB25 surge protector intercepts the transient surges that attack your parallel or serial printer or PC port through the interface cable. The method of surge protection used here adds four benefits to your system.   1) High surge capability : The DB25 surge protector dissipates power upto 600 watts in one milliseconds.   2) Quick response : The protector has response time that is almost instantaneous at one Pico second. Transient surge are clamped at 6.8 V or 18 V for parallel or serial respectively.   3) Low impedance : Once connected to the parallel / serial port, it takes minimum load to your system - about the same as a gender changer.   4) Open failure : Unlike some other surge supressors, this protector falls "open" should your system experience an extreme transient or severe current overload. Therefore if the unit fails, data & surges are shunted to ground instead of back into your equipment.

Power Supply for Electrostatic Precipitator Environmental protection concerns take centre stage today when it comes to fossil-fired power stations and particulate polluting industries. Improved efficiency and enhanced pollution control not only helps to get closer to the objective of a clean environment but also helps industries save valuable raw material going waste. Hirect Power Supplies for electrostatic precipitators with their particularly high efficiency and control leads the way towards clean Environment.   Compact design, ONAN cooling with conservator & breather Hermetically Sealed Construction with corrugated expandable fins EHV grade mineral oil used for ONAN cooling Unique insulation system for silicon oil filled transformers High impedance transformer with in-built current limiting choke Electrostatic Shield between Primary and Secondary windings Proprietary high voltage rectifier stack design consists of module cards with silicon diodes with RC protection across each diode to protect the bridge from the stored charge from the ESP Complete internal assembly is lid mounted for ease of maintenance and repairs

Power Supply for Electrostatic Precipitator Environmental protection concerns take centre stage today when it comes to fossil-fired power stations and particulate polluting industries. Improved efficiency and enhanced pollution control not only helps to get closer to the objective of a clean environment but also helps industries save valuable raw material going waste. Hirect Power Supplies for electrostatic precipitators with their particularly high efficiency and control leads the way towards clean Environment.

Surge Protector, Battery Chargers, fire control equipment, Power Supply

• Features: Lightweight, easy-to-handle, plug-in construction, Superior protection, Remove and test without disconnecting wires,

• Standard: ANSI, IEC, IS,OTHER
• VOLTAGES: 800 to 1200kV

CG started manufacturing metal oxide, station type, line discharge Class-5 Surge arresters in 1994. These surge arresters are mainly used for protection of transformers and reactors for 8001200kV Systems.

Polymer Housed Zinc Oxide Surge Arrester

Lightning Protection System, panel board, structured cables