Arduino Board Dealers in Nagpur

Arduino Original Board UNO with Cable The best board to get started with electronics and coding. Overview: The Uno is a microcontroller board based on the ATmega328P. It has 14 digital inputoutput pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz quartz crystal, a USB connection, a power jack, an ICSP header and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with an AC-to-DC adapter or battery to get started. You can tinker with your UNO without worrying too much about doing something wrong. "Uno" means one in Italian and was chosen to mark the release of Arduino Software (IDE) 1.0. The Uno board and version 1.0 of Arduino Software (IDE) were the reference versions of Arduino, now evolved to newer releases. Features: · The Uno is open-source hardware! You can build your own board. · The Uno board can be powered via the USB connection or with an external power supply. The power source is selected automatically. · The Uno has a number of facilities for communicating with a computer, another Uno board, or other microcontrollers. · The Uno can be programmed with the Arduino Software (IDE). Technical Specifications: Microcontroller ATmega328P Operating Voltage 5V Input Voltage (recommended) 7-12V Input Voltage (limit) 6-20V Digital IO Pins 14 (of which 6 provide PWM output) PWM Digital IO Pins 6 Analog Input Pins 6 DC Current per IO Pin 20 mA DC Current for 3.3V Pin 50 mA Flash Memory 32 KB (ATmega328P) of which 0.5 KB used by bootloader SRAM 2 KB (ATmega328P) EEPROM 1 KB (ATmega328P) Clock Speed 16 MHz Length 68.6 mm Width 53.4 mm Weight 25 g

• Operating Voltage: 5v
• Input Voltage: 7v - 12v
• Microcontroller: atmega8
• Digital io pins: 14 (of which 6 provide pwm output)
• Analog input pins: 6
• Pwm output: pins 3, 5, 6, 9, 10, and 11 can provide 8-bit pwm output

We are offering areduino usb + atmega 8.areduino usb + atmega 8 board is a microcontroller board based on the atmega8. Areduino usb + atmega 8 connects to the computer with a standard usb cable and contains everything else you need to program and use the board and has 14 digital inputoutput pins (of which 6 can be used as pwm outputs), 6 analog inputs, a 16 mhz crystal oscillator, a usb connection, a power jack, an icsp header, and a reset button. Areduino usb + atmega 8  contains everything needed to support the microcontroller; simply connect it to a computer with a usb cable or power it with a ac to dc adapter or battery to get started.Detail : comes with an atmega8 with a pre loaded arduino boot loader auto reset feature pin13 onboard led, with current limiter resistor tx and rx onboard led serial pins : pin 0 and pin 1 can be used to receive (rx) and transmit (tx) ttl serial data external interrupts : pins 2 and 3 can be configured to trigger an interrupt on a low value, a rising or falling edge, or a change in value 8 kbytes flash program memory 512 bytes eeprom

arduino boards, Lcd Module, Waspmote Starter Kit, Adaptor 12V 5A

arduino, Electric Sensors, Electronic Component, microcontroller boards