Process Control Equipment Dealers in Parsodi, Nagpur

  The popular trend in circular loom is also towards the mechanical loom with AC Drive for main Motor. So where there is not much requirement of frequent mesh changing, the mechanical Looms are giving good output with less complexity and simple to maintain.   The increasing cost of spares and the increasing cost of production have put tremendous pressure on Cost reduction techniques. Use of technology and innovative methods has lead to provide you the "Loom PLC card". It can be used for direct replacement and also for old loom’s panel rewiring. This will reduce your overall panel cost , add more useful features and makes it very easy for troubleshooting and maintenance

  The popular trend in circular loom is also towards the mechanical loom with AC Drive for main Motor. So where there is not much requirement of frequent mesh changing, the mechanical Looms are giving good output with less complexity and simple to maintain. The increasing cost of spares and the increasing cost of production have put tremendous pressure on Cost reduction techniques. Use of technology and innovative methods has lead to provide you the "Loom PLC card". It can be used for direct replacement and also for old loom’s panel rewiring. This will reduce your overall panel cost , add more useful features and makes it very easy for troubleshooting and maintenance.

Product Category :  Instrumentation and Control System Lab Trainer (Series: 1000)Product Name : P,PI,PID Control System- Temperature control Model No.: SE-1027 Product Details This has Built-In DC +5V/±12V/500mA regulated fixed Power supply, Variable Reference input adjust, Variable Set Point input control, temperature process P,PI,PID control system, RTD as Temperature sensor, 31/2 digit LED type Temperature Indicator (0C) display, the Temperature controller circuit has Op-Amp IC 741 based Integrator with amplifier as "Integral Controller (I)" and Op-Amp IC 741 based Differentiator with amplifier as "Derivative Controller (D)" wired with Op-Amp based summing amplifier and error controller as "Proportional Controller (P)" to drive the AC Heater input and maintained the temperature of the heater at desired preset value, facility to select P/PI/PID control process, facility to control AC Heater condition, on board Ref/set point/ feedback gain/temp set/PI-Gain/PD-Gain/P-Gain controllers, Electrical Heating arrangement, complete setup with maximum test points. Objectives : To Study the Principle of P,I,D Controller. To Study the Operation of PID Temperature controller. To Study the Temperature controller in Open Loop. To Study the Temperature controller in Closed Loop-PID mode. To Observe and note the ON/OFF of AC Heater at the set value in closed loop. Accessories Included :  Electrical Heating Arrangement, Set of Patch Cords, Operating Manual.  

With vast experience and knowledge in this domain, we are involved in offering an extensive range of Process Control Equipment. Features : Rugged construction Easy to install Application specific design Digital Timer Industrial Process Equipment Water Level Controller

• Voltage: 220 V AC
• Display Type: LED
• PLC Brand: Delta
• Mounting Type: Panel
• Current: 0.5 A
• No Of Inputs: 9 Digits
• Minimum Order Quantity: 1 Piece

We are offering water level controller. Water level controller high quality water level controller is available. With following features switch-less sensing elements. sump sensing (don’t let the motor run if sump is empty). auto and manual toggle switch with led indication. Motor status indicator overflow buzzer in manual mode (optional). functions : switch on the motor when water in overhead tank decreases below the mark. switch off the motor when overhead water tank get filled up to the mark. No need to switch on and off manually. technical specification: single phase 230v supply. sensing wire work upto 250 feet length. up to 5 hp single phase motor can be used warranty terms. Returns are accepted only on grounds of any manufacturing defects. returns shall be accepted within 7 days after receiving product. replacement will be done only after receiving defected product.

electrical temperature indicator, electrical timer, Electronic Items