Temperature Controller Dealers in Bajaj Nagar, Nagpur

Product Category :  Instrumentation and Control System Lab Trainer (Series: 1000)Product Name : P,PI,PID Control System- Temperature control Model No.: SE-1027 Product Details This has Built-In DC +5V/±12V/500mA regulated fixed Power supply, Variable Reference input adjust, Variable Set Point input control, temperature process P,PI,PID control system, RTD as Temperature sensor, 31/2 digit LED type Temperature Indicator (0C) display, the Temperature controller circuit has Op-Amp IC 741 based Integrator with amplifier as "Integral Controller (I)" and Op-Amp IC 741 based Differentiator with amplifier as "Derivative Controller (D)" wired with Op-Amp based summing amplifier and error controller as "Proportional Controller (P)" to drive the AC Heater input and maintained the temperature of the heater at desired preset value, facility to select P/PI/PID control process, facility to control AC Heater condition, on board Ref/set point/ feedback gain/temp set/PI-Gain/PD-Gain/P-Gain controllers, Electrical Heating arrangement, complete setup with maximum test points. Objectives : To Study the Principle of P,I,D Controller. To Study the Operation of PID Temperature controller. To Study the Temperature controller in Open Loop. To Study the Temperature controller in Closed Loop-PID mode. To Observe and note the ON/OFF of AC Heater at the set value in closed loop. Accessories Included :  Electrical Heating Arrangement, Set of Patch Cords, Operating Manual.  

• Type: Digital Temperature Indicators
• Material: Alloy Steel
• Voltage: 0-6VDC
• Display Type: Analogue, Digital
• Driven Type: Battery Use
• Feature: Accuracy, Easy To Fit

Room Temperature Indicator is a very simple temperature monitor circuit used to guess the nature of temperature. The ten LEDs are used to indicate whether it is hot, cold, or lukewarm. Room Temperature Indicator uses a linear voltage display IC1, which drives a display of ten LEDs in a bar or dot mode. Diode D1 in reverse bias mode is used as a temperature sensor.About the Circuit : The drive voltage for IC1 is derived from a potential divider consisting of a sensor R1 and preset P1. This combination is adjusted to set the required operating temperature, so that first LED D1 glows. As the temperature rises further, LEDs glows sequentially. IC1 is a linear voltage display IC consists of 11 comparators which gets sequentially triggered as the temperature rises. Accordingly, LEDs D1 to D10 glows. This is in dot mode. The display can be shown in bar mode also by connecting pin9 to pin3 by switching S2. But it should remembered that in dot mode, the total current will remain below 20mA, but in bar mode it may be 100mA when all LEDs light.

Mould Temperature Controller, Temperature Controller, Industrial Automation

electrical temperature indicator, electrical timer, Electronic Items