Compressed Air Dryer Dealers in Sector 63, Noida

Micro heat regenerated adsorption dryer works in a twin-tower alternative operation mode. Compressed air enters the dryer’s tower A through valve 1A (1B is closed), then is dehydrated and dried under the unique adsorption action of the adsorbent. Finished gas flows to the gas using point through valve 5A (5B is closed); meanwhile about 5% dry air source enters tower B through valve 4B (4A is closed) after being heated by the heater, the adsorbent in which is regenerated after a certain period of heating. Cold blowing begins when heating is stopped, which cools down the adsorption bed in the dryer’s tower B (for use in the next cycle). Finally, the air is discharged into the atmosphere through muffler. Before switching in the second half period, turn off valve 2B and open valve 1B to equalize the pressure in the two towers (to ensure pressure stability when using the gas and avoid the impact and jitter of the dryer), and the second half period work begins at the same time (the dryer’s tower B works and tower A regenerates). The process is similar to that of the previous half period. The process is similar to that of the previous half period. They save energy besides economising purge by reducing the loss of purge to a minimum of 50%. They have controllers with lucid functional displays that are programmable. They secure undisturbed operation despite tower changeovers. The moisture load is lessened by the auto drain valves in pre and oil filters. Therefore the desiccant life is secured without any extra cost. The inclusion of a unique purge economizer in the latest microprocessor based controller which facilitates manual setting up of the dryer load. This device can not only accept up to 3 compressor load/unload contacts but also compute the dryer load dynamically. According to these settings done, the purge can be set. Also, the purge air can be controlled according to the pressure input accepted by the controller.

• USES: Telecom industry, Pneumatic control systems, Textile industries, Pneumatic tools, Paint industry.
• Features: Economical functioning, low power consumption, Innovative heat exchanger design .

Having the support of an expert team, we have successfully developed Refrigerated Air Dryers. These dryers worked on the principle of compressed air with saturated water vapor that enters the dryer's pre-cooling device. This air is cooled down with outgoing cold air, thus reducing the load of the system.

The Heat of Compression (HOC) dryers are No-Purge Loss type desiccant dryers based on adsorption principle. The hot air from the Compressor at min 120 deg C and higher temp, is used directly for regeneration of the desiccant. After regeneration, this air is cooled down to 40 deg C and then it is dried in second tower. Thus, the use of heaters is eliminated. For eg. in the 6+6 Hrs. Cycle the hot air is fed for regeneration for 4 Hrs. and for balance 2 Hr. a changeover takes place where the air is first cooled in cooler, then dried and before going to the outlet, cools the regenerated desiccant bed, thus bringing it down to ambient temperature. This cycle is reversed for the next 4Hrs. where the Adsorber drying the air in the previous cycle goes for regeneration and vice versa.It’s having least running cost with best quality of air.   Salient Features: Having least running cost Best quality of air Lesser payback period Continuous duty with long efficient service life Easy to install and user friendly Capacity: 750 CFM to 6000 CFM Dew Point: -40 to -60°C ADP Purge Loss: NIL

Refrigerated Air Dryer, water cooled scroll chiller, Air Receiver