Oil & Stain Cleaner Dealers in Noida

Manufacturers of special type of three/ four stage ultrasonic vapor degreasers with indirect heating in vapor chambers, which not only saves electricity but also avoids tce to disintegrate. Extra cooling coils are provided in the trough to minimize the vapor losses. A proprietor designed water separator will be attached to the tank for removal of atmospheric water mixed during condensation. Material of construction 316 grade, 1.6mm thick stainless steel size: we make custom designed cleaner as per individual requirements.

THREE- STAGE VAPOR DEGREASER WITH OIL BATH HEATING Advantage of oil bath heating : 1) In direct heating the heaters are directly in contact with the solvent & the temperature near the Heater tube is much higher which in turn disintegrates the solvents chemical properties. 2) As it is a known fact that we can not increase the boiling point of a particular solvent beyond its boiling point. For example if the boiling point of water is 100 degree “C” it will remain the same even if we boil it for more time It will not reach 101 degree until unless the atmospheric pressure is changed or the chemical properties are changed. Similarly if the boiling / vapor temperature of solvent is 70 degree C it will not go beyond 70 degree with the result the thermostat will Not cut the heaters if the thermostat is set for 70 degree C. With the result the heaters will be continuously on ; which will increase the electrical consumption & disintegrate The solvent due to excess heat near the heater tubes. 3) In oil bath indirect heating the temperature of the oil is raised 10-15 degree C. Above the boiling point of the solvent. Once The temperature reaches the desired set point the heaters are cut off & the continues vapor is formed. Since this tank is Completely insulated the heat loss is minimum. 4) Heater life increases drastically. 5) Recyclable life of the solvent increases. 6) No scale forming due to over heating.

The oil from a pressure point on an engine is fed through the side inlet of the Centrifuge. When the oil pressure exceeds 1.3 to 2.5 BAR, the spring loaded plunger will be pushed back and the oil enters the rotor assembly through the central spindle. The rotor assembly gets pressurized and the only exit point for the oil are the two tangentially opposed nozzles at the base. The rotor assembly has two bushes, one at the top and one at the bottom and spins freely around the spindle. The action of oil exiting through the nozzles gives it a reverse direction spin. The centrifuge has no consumable parts and is capable of removing sub micron particles from the oil. Ensure that the minimum operating pressure is at least 4 BAR and should not exceed 7 BAR. Optimum results are achieved at 5 BAR pressure.

• Form: Liquid
• Application: Hospital, Clinic
• Packaging Type: Plastic Can
• Packaging Size: 5 Ltr
• Feature: Accurate Composition
• Boiling Point (deg. Celsius): 60* C

HD Machine Cleaning Disinfectant Pre-pump and post-pump tubing sets options Medical grade clear tubing Guarded access ports for reduced infection risks Parts of superior quality, unique design and high performance Male/Female Luer locks in compliance with related international specifications 100% tested for leakage and other parameters Universal design for use with all haemodialysis machine types High flow rates maintained consistently with superior quality components and tubes Smooth inner surfaces reduce foaming and facilitates removal of air Colour-coded clamps and dialyser connectors for easy identification

centrifugal oil cleaners, oil filtration equipments

vapor degreasers, Ultrasonic Cleaner, industrial cleaning chemical

centrifugal lube oil filter, Oil Filter, oil conservation products

multi stage vapour degreaser, multi stage aqueous ultrasonic cleaners