Analytical Instruments Dealers in Shivane, Pune

• Measuring Range: 0-14 pH (4-20mA)
• Output:  4-20mA (scalable to 0-14 pH),500 Ω at 24 V DC
• Operating Temperature: -25 to 70 Degrees C
• Accuracy: ±.02pH (±2mV)
• Input:  pH electrode with BNC connector, Solution ground
• Power Requirement: 12-24 V DC
• Temperature Compensation: Automatic
• Repeatability: ±.01 pH (±1mV)
• Linearity: 0.1% of Span

The P-420 (encapsulated PH Transmitter) is a 2-wire, 4-20 mA PH transmitter having encapsulated construction, High performance and compact size. It can be interfaced with any display and control devices requiring a 4-20 mA input.Transmitter accepts input from any PH combination electrode through BNC Connector. It transforms the PH signal to a 4-20 mA Current proportional to the PH level 4-20 Output from PH transmitter can be transmitted over two wires to control device. Same two wires used to suppy power to loop.Any 12-24 VDC Power supply can be used. There are two adjustments on transmitter to standardize probes for "ASY" and "SLP".Features:• 4-20 mA Loop Powered•  Easy To Use• Compact Size• Adjustable ASY and SLP

We are offering power quality analyzer voltage and current thd, current tdd and k-factor, up to 50th order harmonic, true rms measurement with 128 samplescycle, en50160 compliance statistics, harmonic survey statistics, ieee519 & ieee 1159 measurement compliance, iec 61000 flicker, cbemaitic, iec 6100-4-7 harmonics, tou energy measurement, standard rs-485 communication port and an additional plug-in rs-232rs-422rs-485, ethernet, profibus, gprs module, true rms volts, amps, power, power factor, neutral current, frequency, two independent, simultaneous waveform recorders with upto 2000 post fault cycles 5060400 hz measurement capabilities, class 0.2s iec 62053-22 four-quadrant active and reactive energy meter, three-phase total and per phase energy measurements; active, reactive and apparent energy counters, real-time waveform monitoring capability, add on tou, rtc, dido modules.

The thermal analysis is a quick, reliable, & low cost application method enabling quality & melting process control of cast iron. From ironcarbon state diagram the thermal analysis gives direct information about solidification of cast iron. It allows analysis of carbon equivalent (%CE), Carbon (%C), Silicon (%Si) in iron melts like Grey cast iron, Ductile iron and Malleable iron. Principal of Operation: Thermal Analysis is the interpretation of cooling curve of liquid iron sample. First arrest point, the liquidus is a temperature level is directly related to Carbon Equivalent. CE = %C + %Si3 + %P3. Second arrest point, the solidus temperature, when referred with liquidus, allows the total carbon content prediction. For this; metal must solidify white which is achieved by Tellurium This specially designed Tellurium & other ingredient minimises the influence of entrapped particles, gases and particularly additions used in cupola produced iron. Our smart carbon cups are tellurium coated sensors with "k" type thermocouple can be used for Carbon Equivalent, % Carbon, % silicon in grey, malleable & base metal of ductile iron. Carbon cups are available to cover entire range of thermal analysis i.e. % Carbon + % Silicon9 = 4.3.

EXHAUST GAS ANAL YSERS 8020 . 8040 sampling probe length: 6 m Warm Up: Automatic [maximum warm up time: 5 minutes) Mains Voltage: 187 + 264 Vac Mains Frequency: 50 Hz [::t2%) Power Consumption: 150 W max Mains Fuses: 2xT4 A ENVIRONMENTAL OPERATING CONDITIONS: Operating Temperature: 5 + 40°C Relative Humidity:

• Features: Reliable High efficiency Easy to operate

These results are proportional to the conductivity of the free lime. Instrument consists of two temperature controllers, a conductivity measurement system, and logic controller stage. The sample weighing mechanism is also built in.

Humidity Analyzer

flash chromatography systems, spe cartridges, Specialty Chemical, catalysts

We are offering free lime analyzer. Specifications operates on a single phase 230v ac, 50hz supply 128 x 64 lcd with backlit membrane keypad weighing balance to measure up to max capacity of 300gms

ph testers, cleaning maintenance services, Vacuum Suction Sweeper

foundry analytical instrument, Electronic Instruments, molten metal equipment

Analytical Instruments, Data Logger

Power Quality Analyzer, Hot Wire Anemometers, Sound Level Meters