Arduino Board Dealers in Pune

• Country of Origin: India
• Type: Automatic
• Color: Blue
• Condition: New
• Architecture: AVR
• Microcontroller ATmega328 (SMD) – Interface CH340G: Digital I / O Pins 14 (of which 6 provide PWM output)
• Input Voltage (recommended): 7-12V: Input Voltage (limits): 5-20V

• Brand Name: Arduino
• Clock Speed: 84 MHz
• Features: These are compatible with all arduino compatible shields and the arduino ide, It has a standard 6x1 avr isp header, It comes with an atmega328 with a pre-burnt arduino boot loader.
• Operating Voltage: 1.8 - 5.5 V
• DC Current : 800 mA
• Packaging Type: Box
• SRAM: 96 KB

• Type: Automatic, Semi-automatic
• Material: Plastic
• Color: Blue, Green
• Voltage: 7-12 V, 7-12V
• Condition: New, Used
• Power: 20 MA, 40 MA, 60 MA
• Current Type: AC, DC
• Clock Speed: 16 MHz, 18 MHz, 20 MHz
• Architecture: AVR
• Analog Input Pins: 12, 16, 6, 8

• Clock Speed: 16 MHz
• Operating Voltage: 5 V
• Input Voltage: 6-20 V
• DC Current for 3.3V Pin: 50 mA
• DC Current per I/O Pin: 40 mA
• SRAM: 2 KB (ATmega328)
• EEPROM: 1 KB (ATmega328)
• Operating Temperature: -40 to +90 Degree

UNO PLUS is a development board compatible with the Arduino UNO R3, an improved & enhanced alternative solution for Arduino UNO R3.   ATMEGA328P-AU AMS1117-3.3 : 3.3V voltage regulator NCP1117ST50T3G : 5V voltage regulator FT232RL : USB to UART convertor Arduino interface compatible with standard Arduino interface with two additional analog inputs A6 (config the CFG), A7 solder pads provided, supports prototype breadboard ICSP interface MICRO USB connector : for uploading program OR serial port debugging Power output header : 3.3V OR 5V, voltage level configured by the onboard power configuration switch, used as power output OR common-grounding with other boards FT232 pins : for burning Bootloader into the microcontroller DC input : 7V ~ 12V Reset button Power indicator Serial port Rx/Tx indicator User LED Power configuration switch : for configuring the operating voltage Bootloader selection switch turn ON : the board will reset when power-up OR other USB devices were detected connecting to the PC turn OFF : the onboard program runs immediately when power-up, and the board will not reset when other USB devices were detected connecting to the PC

Arduino Uno Board, Cable Float Switch, power transistor

Arduino Nano Microcontroller Boards, Smart Card