Hospital Autoclave & Sterilizers Dealers in Erandwane, Pune

• Insulation Wall: Single Wall
• Type Of Dental Chair: Fixed
• Operation Mode: Electrical
• Size: 300 x 150 x 100 mm
• Application: Dental Treatment,Dental Surgery,Dental Examination

simply placing transformer in autoclave vessel under vacuum will not remove moisture form that. For evaporating water into steam latent heat of water is to be supplied.when transformer put in to the autoclave for drying heat energy is transferred to transformer via convection and radiation. Compared to convection energy transfer by radiation is very low. During vacuum drying as air is sucked out there will not be any transfer of heat by convection. This necessitates heating by hot air of sufficient duration,before vacuum drying in the autoclave vessel by externally either by thermic fluid heating systemelectric heating systemsteam heating by means of radiator coils inside autoclave or limpets welded outside the autoclave..

Technical data Applicable for the refrigerants R717 (ammonia, Nh3), HFC, HCFC (e.g. R22, R134a, R404a) and other refrigerants dependent on sealing materials compatibility within a temperature range of -30°C/+100°C Flammable hydrocarbons are not recommended.    Pressure setting range : 10-25 bar (145-363 psig) the valve is designed for strength test : 40 bar (580psig). Leakage safety: Same as set pressure. For further information please contact your local Castle Sales Distributor.   Important : The CSRVA safety relief valve is dependent on the back pressure (if the back pressure is higher than the atmospheric pressure, the opening pressure will be higher than stated set pressure) Special circumstances such as vibrations (which should be avoided) and oscillating pressure may require an increased difference between the operational pressure and the closing pressure.   Pressure Setting : The operating pressure of the plant should be at least 15% below the set pressure. This allows a perfect re-seating of the safety relief valve after having been activated. .   Temperature Range : -30/+100°C.

• Material: BOPP, PTFE Fabric, Textured Paper
• Application: Clinic, Hospital, Laboratory & Pharma, Sealing
• Color: Brown-yellow, Creamy, Creamy-brown, Off White, White
• Adhesive: Acrylic Based, Hot Melt Adhesives, Nature Rubber, Pressure Sensitive, Silicon
• Adhesive Side: Double Sided, Single Sided
• Feature: Acrylic Based, Hot Melt Adhesives, Nature Rubber, Pressure Sensitive, Silicon
• Design Printing: Offer Printing, Plain
• Certifiacation: ISI Certified, ISO 9001:2008 Certified

The outer chamber is made of heavy gauge stainless steel Inner chamber, Lid, support ring & support legs are made of complete stainless steel ( 304 grade ) dully polished. Unit is supplied with Radial locking system, Pressure gauge, spring loaded safety valve, water inlet, water outlet, steam release valve, water level assembly, paddle lifting arrangement. Control box fitted with Pressure control switch, low water cut off,

Water Heater, Industrial Ceramic Heater, Porcelain Heater

medical autoclave, Hospital Equipments, intestinal surgical equipments

Steam Sterilization Rolls, Absorbable Medical Underpads, Tyvek Gusset Pouch

Air Sterilizer, Air Ionizer, Air Purifier, air sterilizers

Safety Valves, Bellow Seal Valve, condensate recovery system