Dial Indicators Dealers in Pune

• Tool post holder: 9.5 * 19 * 150
• Upright spindle: 8 dial * 115 L
• Universal Clamp: 6.5 and 8 holes
• G – Clamp: 33 capacity round or flat

Rectangular Holder type AM 8 mm*4.8 mm pin diameter 4 mm.Rectangular Holder Type BM 13 mm*6mm, pin diameter 4 mm.Cylinder Holder Type CM 9.5 mm diameter, pin diameter 4 mm.Swivel Clamp with Dovetail Holder (Metric models) Bore diameter 4 – 9.5 mm.Knuckle Joint Holder (Dovetail).Rectangular Holder Type A 5 / 16 “ * 3 / 16,pin diameter 1 / 4 “Cylindrical Holder Type C 3 / 8 “ diameter pin diameter 1 / 4 “.Swivel Clamp with Dovetail Holder (Inch models) Bore diameter 1/4–3/8 ”.   Extra contact points With Domed Anvil and Round Anvil Tommy bar. Hole attachment with indicator Mounting hole and swivel Arm 9.5 hole for dial indicator.

t's universal design enables it to calibrate both plunger and lever DTI's (Dial Test Indicators). It can also be used for calibration of bore gauges. The unit also determines gauge hyteresis which is not possible using conventional gauge blocks. This dial gauge calibrator can be used in calibration laboratories and also be used for roaming shop floor gauge calibration checks as it is a portable device. The test is performed by comparison with the master gauge. The calibrator uses the Abbe's principle. SPECIFICATIONS : 25 mm travel covering the majority of common indicators Accepts lever indicators with stylus up to 40 mm long Computer interface for efficient calibration reports. Plunger dials with 8mm or 38” shank can be tested. Bore gauges up to 150 mm can be checked. The standard Kit incorporates, Cary case ModelDGC-25 calibrator Master gauge (Baker Electronic Dial Gauge ED1) RS 232 cable to transfer output to computer with software Magnifying glass 38” to 8 mm stem mounting sleeve. Bore Gauge holding bracket and extension rod. For more details and enquiry please contact.

Dial Indicators, propeller blades, Industrial Power Hammer