Electronic Test Instruments Dealers in Alandi, Pune

• Steel: 1",2",3",1/2",1/4",4",6"
• Steel: 1",2",3",1/2",1/4",4",6"

We can supply Gas Meter within the working range of the meter the rotor spins proportional to the actual velocity of gaseous material flowing. A pick-up sensor produces an electrical signal as each blade crosses through its low magnetic or rf field. This signal is amplified and conditioned by a transmitter or fed directly into a rate/totalizer, and represents the actual cubic feet per minute (acfm) flowing through the meter. The k-factor is stenciled on the meter body in pulses per actual cubic feet (p/acf). Because gases are compressible, most people desire to measure the equivalent amount of gas corrected for the line pressure and temperature to standard cubic feet per minute (scfm at 60â°f, 14.69 psia). If the flow temperature and pressure are relatively constant, then a simple correction can be calculated to shift the k-factor from p/acf to p/scf and a simple totalizer (measurement systems india make ) may be used. When flow temperature and pressure are not constant, a flow computer. specifications linearity 1 â±1.0%/0.5% repeatability 1 â±0.25% maximum over-range 125% of flow rate for intermittent periods frequency output 0 to 1,100 hz voltage output approximately 100 mv@ 100 hz to 1.5 v (rms)@ 1,000 hz. Pressure drop 0.5 psi at 100% of flow range pressure rating we manufacture flowmeters for most pressures. installation vertical or horizontal (any direction). Materials of construction body: 316 l stainless steel. Flanges: 316 stainless steel rotor: 431 stainless steel. Rotor shaft/bearings: standard: tungsten carbide v-cup cartridge frame retainer: 302 stainless steel cartridge frame: 316 l stainless steel. Temperature range:meter with bearing structure of: standard: tungsten carbide: -40â°f to 300â°f (-40â°c to 149â°c). For other temperatures consult factory.

• Brand Name: USIS
• Display: Digital
• Voltage: 110 VAC,230 VAC,240 VDC
• Size: 15 mm to 450 MM
• Material: SS316L
• Usage/Application: ETP
• Frequency: 50 Hz
• Protection Class for Sensor: IP65

We have massive warehouse with Individual stock keeping units (SKUs). We are capable of sorting the products in an efficient way and can easily entertain bulk requirements of the customers. We understand that high-quality standards should be maintained throughout the offerings. And, for attaining this objective, we make use of superior-grade raw material for manufacturing the same.

flow meter for water /alcohol/fermented wash/molasses.

We are dealing in btu meter, Based on calculations of thermal power & energy consumed through measurement of flow, temperature difference of inlet & outlet of the medium. 4-20 mA output proportional to power output 16x2 LCD, 9 digits for total energy & 5 digits for instantaneous power. The engineering unit can be selected as either KW & KWHr or BTUHr & BTU. Communication port RS 232485 is available with MODBUS RTU. Backup of totaliser on power failure in non volatile memory Logging history can be viewed on the screen Ingress Protection: IP65 Equivalent

• Steel: 1",2",3",1/2",1/4",4",6"
• Steel: 1",2",3",1/2",1/4",4",6"

within the working range of the meter the rotor spins proportional to the actual velocity of gaseous material flowing. a pick-up sensor produces an electrical signal as each blade crosses through its low magnetic or rf field. this signal is amplified and conditioned by a transmitter or fed directly into a ratetotalizer, and represents the actual cubic feet per minute (acfm) flowing through the meter. the k-factor is stenciled on the meter body in pulses per actual cubic feet (pacf). because gases are compressible, most people desire to measure the equivalent amount of gas corrected for the line pressure and temperature to standard cubic feet per minute (scfm at 60ã�â°f, 14.69 psia). if the flow temperature and pressure are relatively constant, then a simple correction can be calculated to shift the k-factor from pacf to pscf and a simple totalizer (measurement systems india make ) may be used. when flow temperature and pressure are not constant, a flow computer. specifications linearity 1 ã�â±1.0%0.5% repeatability 1 ã�â±0.25% maximum over-range 125% of flow rate for intermittent periods frequency output 0 to 1,100 hz voltage output approximately 100 mv@ 100 hz to 1.5 v (rms)@ 1,000 hz. pressure drop 0.5 psi at 100% of flow range pressure rating we manufacture flowmeters for most pressures. installation vertical or horizontal (any direction). materials of construction body: 316 l stainless steel. flanges: 316 stainless steel rotor: 431 stainless steel. rotor shaftbearings: standard: tungsten carbide v-cup cartridge frame retainer: 302 stainless steel cartridge frame: 316 l stainless steel. temperature range:meter with bearing structure of: for other temperatures consult factory.

• Brand Name: Mass Flow
• Size: 10mm to 1000mm
• Place of Origin: Pune, Maharasthra
• Condition: Good
• Feature: High durability, robust structure and resistivity to adverse

We offer Digital Gas Flow Meter as Per Customers’ Requirements. Our Standard Sizes are Up to 10 Inches and Can Be manufactured as per the needs of the customers. We are recognized as one of the prominent Digital Gas Flow Meter Manufactures, Suppliers and Exporters. These Digital Gas Flow Meters are ideally designed to measure the rate of flow of fuel gases consumed for Commercial Industrial or Residential purposes. The use of optimum quality materials in the manufacturing of the Digital Gas Flow Meter ensures high durability, robust structure and resistivity to adverse conditions. Details - Steel Insertion Type : Inline Type Sizes Available 10mm 15mm 20mm 32mm 40mm 50mm 65mm 80mm 100mm 125mm 150mm 200mm 250mm 300mm 400mm 500mm 600mm 800mm 1000mm     Temperature Compensation     Pressure Compensation Optional     Humidity Compensation     Density Compensation     Material Used - Steel    Types - Mechanical gas flow meter series EQZ Mechanical gas flow meter series TRZ GWF Volume Corrector ELCOR 2 SS Turbine Flow Meter Vortex Mass Flow Meter Thermal Mass Flow Meter Turbine Type Mass Flow Meter with Pressure and Temperature compensation Diaphragm Gas Meters Ultrasonic Flow Meters Coriolis Mass Flow Meters

• Accuracy: Upto ±0.5%
• Size Range: 15 NB to 900 NB
• Temperature Range: Upto 100 Deg.C
• Case Protection: IP 65/IP 66/IP 67
• Materials: Stainless Steel
• Process Connection: Flanged as per ASME B16.5

• Application: Laboratory
• Frequency: 50 Hz
• Phase: Single Phase

• Conductivity: 14 selectable ranges
• Min. measurable conductivity: 50 µS/cm
• Max. measuring span: 1000 mS/cm
• Min. measuring span: 500 µS/cm
• Max. measuring error: ± 1.0 % FSR , 0 … 1 mS/cm to 0 … 500 mS/cm ± 1.5 % FSR , 0 … 1000 mS/cm ± 1.5 % FSR , 0 … 500 µS/cm
• Reference temperature: 25 °C , adjustable
• Repeatability: < 0.5 % FSR ,> 1 mS/cm
• Compensated temperature range: -20 … 150 °C
• Temperature compensation: 0.0 … 5.0 % FSR/K , adjustable
• Step response time: ≤ 2.0 s
• Sample time: ≤ 0.4 s
• Concentration: 4 factory set media
• Customer defined media: Customer defined (30 point lookup table)
• Temperature: Free programmable range
• Measuring range: -20 … 150 °C
• Thermal response time, T90: ≤ 15 s
• Max. measuring error: ± 0.4 K
• Process temperature: -20 … 140 °C , permanent 140 … 150 °C , max. t < 1 h
• Process pressure: ≤ 25 bar
• Connection variants: G 1 A hygienic
• Wetted parts material: PEEK Natura
• Surface roughness wetted parts: Ra ≤ 0.8 µm
• Properties: Universal commands Common-practice commands Conductivity device family commands Device Specific Commands For more information please see ‚HART Field Device Specification‘
• Protocol: HCF standard, Rev.7
• IO-Link version: 1.1
• Device profile: Smart Sensor Profile
• Baud rate: 38,4 kbaud (COM2)
• Cycle time: ≥ 8,4 ms
• Process data length: 128 bit
• SIO-mode: Yes
• Process data (cyclic): Switch state Signal analog output 1 Signal analog output 2 Temperature Unit temperature Conductivity Concentration Actual measuring range
• Degree of protection (EN 60529): IP 67 IP 69K , with appropriate cable
• Cable lengths: 10.0 m 5.0 m 2.5 m
• Material: PUR
• Temperature: -40 … 80 °C
• EMC: EN 61326-1
• Hygiene: 3-A (74-07) EHEDG EL Class I FDA (21 CFR 177.2415)
• Safety: cULus listed, E491206

• Color: White

Full stainless steel construction with PTFE Liner. Suitable for any type of Dairy Fluids like milk, cream etc. Also suitable for Pharma liquids, juices of various fruits. Available in two types of end connections; SMS or DIN Union and Tri-Clover clamps. Sizes available from DN25 to DN100. Lower Sizes on Request. Highly Accurate and Linear. Isolated Analog and digital Output.

• Weight: 0.82 kg
• Accuracy: +/- 0.5 percent
• Repeatability: +/- 0.15 percent
• Display Type: Digital
• Usage/Application: Industrial
• Flow Range: 1.9 to 57 lpm
• Maximum Pressure: 34kPa,0.3 bar
• Flow Range: 1.9 to 57 lpm
• Maximum working pressure: 10.3 MPa, 103
• Minimum working pressure: 34kPa, 0.3 bar
• Operating temperature range: -20°C to 50°C
• Storage temperature range: -25°C to 50°C
• Wetted parts: Stainless steel, PBT (polybutylene terephthalate) nickel, nitrile rubber
• Batteries: 2 AA alkaline
• Expected battery life: 6 to 12 months

lighting automation system, SIGNAL TRANSDUCERS, SWITCHED MODE POWER

• Brand: Scope
• PC Connectivity: Ethernet
• Sampling Speed: 1/2/5/10/20 kC selectable
• Travel Channel: 3 Travel characteristic
• Best Time resolution: 50 muS

The GFMc-150 flow meter is applicable for measuring flow rates of Bio-gas, LPG, Compressed air and other compressed gases in closed conduits. It is best suited for applications where affordability, reliability and ruggedness are of prime concerns.

• Brand Name: Multispan
• Power Source: 230VAC
• Country of Origin: Made in India
• Model Name/Number: AVF 19N
• Usage/Application: Industrial
• Dimension: 96 X 96
• Display: Digital
• Usage: Industrial
• Supply Type: Auxillary
• Number Of Wire: 3
• Condition: New

• Display Type: LCD Digital
• Brand Name: CURTIS 
• Voltage: 12-24V DC
• Features: High Strength frame to protect the operator , to protect the operator and goods 
• Usage/Application: Industrial
• Model: 840R

• Brand Name: SCOPE
• Power: AC 220V/110V, 50/60Hz DC (from battery bank under test)
• Temperature: 0C To 50C
• Humidity: 5 To 90% Relative humidity (non-condensing) Request Callback
• Display: LCD , 128*64 pixel
• Sampling Frequency: 5 Samples/min

• Feature: Motor Control Center Panels, Process Control, Energy Management System (EMS)
• Type: Digital
• Frequency: 50Hz +-5.0%
• Size: 96 x 96 x 110 mm
• Working Temperature: 0 to 55 Degree C
• Relative Humidity: 30-95% non-condensing
• Secondary Current: 1 or 5A (Site selectable)
• Power Consumption: Less than 3VA
• Power Supply: 90 - 270VAC, 50/60Hz or 1 1 0 - 3 7 0VDC

• Frequency: 60 Hz
• Country of Origin: Made in India
• Brand Name: Microfix
• Usage/Application: Laboratory
• Display Type: Digital
• Body Material: Mild Steel

• Warranty: 6 Months
• Brand: Fluke
• Digit Display: 4 Digit
• Battery: 9 VOLT

This Data acquisition IOT system is new technology offer by JKS Techfor various industrial use to capture real time process parameters for process control. This system can give data of various process plant and testing machineries.  

The 3 Phase CT Operated Trivector Meter is designed for metering of HT/LT consumers and for feeders. The meter has advanced data and tamper recording capabilities and is provided with communication ports Features: Class 0.2s, 0.5s, 1.0 as per relevant IS and IEC Standards 1A and 5A current rating 3 Phase 4 Wire/3 Phase 3 Wire system Anti-tamper features Self-diagnostic capability Multiple tariff / Time of day feature Upto 3 Maximum Demand registers Load Survey (Interval Data) features Upto 12 reset backups Optical port/RS 232/RS485 (optional)

• Memory: 2 GB
• Warranty: 1 Year Against Manufacturing Defect
• No. of Channels: Multichannel
• Power Supply: SMPS 85-240 VAC
• Interface: PC / PENDRIVE
• Export of Data: PDF / EXCEL
• Accuracy (%): 0.25 %
• Sampling Time: 1 sec for 04 ch / 2 sec for 08 ch
• Panel cutout: 78[h] x 154[w] , depth : 144[d]