Gas Torch Dealers in Pune

Delux Gas (Propane or Butane) Torches in compliance with regulations ISO EN 9012 Instructions for correct useUse exclusively in open airPlease make sure that flexible hose has been correctly connected rigourously in order before to the welding torch and then to gas cylinder Ignition1. Close both small tap and black knob clockwise?2. Open the main tap of the gas cylinder?3. Regulate Gas Pressure through the valve placed on the gas regulator (if provided)?4. Push button located on security valve (if supplied) until the hose is totally fulfilled with gas?5. Slightly open the black torch knob?6. Ignite the torch. Regulate the brass knob to obtain desired pilot flame.7. Pull the lever to get maximum output (the black knob controls the lever gas flow)?8. In case of wind or inclement weather conditions, increase the pilot flame by turning anticlockwise the small brass knob Turn Off1. Close the main tap on the gas cylinder2.Consume all the residual gas in the rubber hose3. Close the torch taps and knobs Safety Devices:1. An excess flow security valve is placed on the regulator for immediate stop of gas flow in case of rubber hose damage or sudden pressure change due to external causes?2. A torch stand is provided as standard equipment in order to lay the torchwhen in use. This allows the torch to rest in a upright position onto the floor.

• Features: Longer size, Heat resistant, Reliable

• Type: Cutting Torch
• Material: Brass
• Cutting Width: 100 mm
• Fuel Gas Type: Oxy-Acetylene
• Brand: GCE
• Torch Type: Gas Torch
• Weight: 800gm
• Cutting Range: 3-300mm
• Length: 250 mm
• Cutting Capacity: 100mm
• Hole Piercing: 10 mm
• Max Flame Temperature: 2509

NM Gas Cutting Torch, Stainless Steel Flux Cored Wire, Messer Gas Economiser

Gas Cutting Torch, LPG Regulators, Gas Cutting Spares, Co2 Regulator

Gas Heating Torch, Welding Hand Shield, Acetylene Gas Regulator

Gas Torch, Welding Rotator, Induction Welder, Laser Welder

Gas Cutting Torch