Magnetic V Blocks Dealers in Bhosari, Pune

MRM – 475, 475 H, 575, 575H, 676, 676H, 856, 856H, 876, 876H, 976, 976H These Magnetic –Vee blocks are invaluable and versatile in tool – making and inspection, in quality control and tool – room. Due to their extremely high magnetic power they can be used for drilling and grinding (both wet and dry) and even for light milling work. The  - Blocks have a total of three magnetic surfaces. Top and bottom each with 90-degree v – angle and end surface opposite from switch. All three magnetic surfaces as well as the two sides are carefully ground. Their accuracy for flatness, parallelism and square ness is within 0.005 mm or 0.0002 inches for all work, which requires accurate positioning. When turned ‘ON ‘ all three magnetic surfaces are activated simultaneously. The permanent magnet holds the work firmly in the V and the block holds itself firmly on a ferrous surface. Coolants or other fluids cannot damage the magnetic system, being shielded from penetration of moisture.

'V’ Blocks are required for Quality Control, Tool Room and Standard Room. "Crystal" Brand Magnetic 'V’ Blocks have high magnetic pull, hence they can be used fro drilling and grinding (both wet and dry) and even for light milling work.

Used for grinding, light Miliing, Drilling & inspection of round & square Jobs.Surface A, B, C, D are hardened to hardness 60 ± 2Rc. Two V block per set.Uniform and Strong magnetic pull to all three magnetic surfaces,Top, Bottom & V Faces. Specifications: SrNo. Cat No. Size Range (mm) Pull 1.UL-32001 Hard 40L X 40W X 50H [2"] Ø 3 - Ø 25 25 Kg 2.UL-32002 Hard 75L X 56W X 75H [3"] Ø 5 - Ø 40 75 Kg 3.UL-32003 Hard 100L X 70W X 95H [4"] Ø 5 - Ø 65 100Kg 4.UL-32004 Hard 150L X 75W X 100H [6"] Ø 5 - Ø 70 125Kg 5.UL-32005 Hard 200L X 125W X I50H [8"] Ø10 - Ø140 175kg

MagTech Magnetic ‘V’ block’ is basically a clamping device. Hence, it is used in Standard Room Tool Room and Shop Floor also for Drilling, Grinding Light Milling operations. The 'V’ Block has a total three magnetic surfaces. Top, bottom with 90 degree angle and end surface opposite from switch. Magnetic surfaces are activated by mechanical ON-OFF switch. All three magnetic surfaces and the two sides are carefully ground. The main ‘V’ angle and bottom surface are provided with hardened steel plates, that ensures extra wear resistance. The accuracy of flatness and parallelism and squareness is within 5 microns for 4” & 6”; as well as 10 microns for 8” ‘V’ blocks. The following photograph can explain the product and its utilization briefly. 'V’ Blocks are required for Quality Control, Tool Room and Standard Room. Our Magnetic 'V’ Blocks have high magnetic pull, hence they can be used for drilling and grinding (both wet and dry) and even for light milling work. When turned "ON" all three magnetic surfaces are activated simultaneously. The permanent magnet holds the work firmly in the 'V’ and if the block rests on a magnetically conductive surface, it is held firmly to this surface. The magnetic pull is constant and will not decrease even after long use. The magnetic system being shielded from penetration of moisture, cannot be damaged by coolants or other fluids.