Passive Infrared Sensor Dealers in Pune

Ceiling Mounted PIR Microwave, Ultrasonic Sensor Module

• Features: Rugged design, excellent detection capability and reliability

• Good quality sensor element: white ABS plastic body
• compact size: good aesthetical look
• ceiling or wall mounting option: , low power consumption

We are offering sensor, sensor switch, pir, motion sensor, occupancy sensor, energy saving, energy saver. The pir sensor is used to curtail wastage of electrical energy. This passive infra-red sensor detects heat radiated from moving persons objects and uses this ability to automatically switch on or off lights, air conditioners etc these products can be used in all places where electrical energy is wasted in absence of human presence, like office cabin, back office area, lobby, conference room, changing room, recovery room, cloak room, corridor, staircase, storage places, warehouse, car parking, toilet, kitchen, pantry, garden, etc. to know more about the product please read the following, the sensors installed will detects when somebody or a moving object ( say a car in car parking area opening of a door ) enters in its detection range and will switches on the lights and will turned off the lights when person leaves out the movement stops. Clearly, the sensor is intended to operate lights at an area corresponds to movement occupancy. I.e. On the lights when there is movement occupancy and off the lights when there is no movement occupancy. Apart from this energy saving aspect, it also offers a convenience that it is not needed to often switch on or off the lights; it is in automatic operation. there are three knobs in the sensors, the lux knob, the time knob and the sensitivity knob. The lux knob is used to make the lights on at a desired lux level. The time knob is used to make the light lights off at a desired time period ( of 1 minute to 15mnts). Ex: if the time is set for 3minutes, the lights will turn off after 3 minutes, if there was a movement at the end of 2minutes, then the lights will be off only after 5minutes(=3+2). This way if there is an occupancy movement in the detection area distance the lights will remain on. The sensitivity knob is used to increase decrease the detection distance area. Every sensor has a detection distance,( for the ceiling mount sensor, when erected at a height of 3.00 mtrs, it covers a an area of 6mtr radius) it can be mounted on ceiling wall, the mounting height varies from 1.8 mtr to 3.8 mtrs. An electrician can easily install this device. Every sensor is attached with an installation manual showing connection diagram.

• Light level threshold: 10 to 1275 lux
• Standby consumption: 0.75 W
• Optimum distance between 2 sensors: 6 m
• Adjustable time delay: 10 s to 10 min
• Recommended fixing height: 2.5 m

A NEGAVEEZ PIR Motion Detector offers security and convenience in the areas that they cover. Motion detector is an intelligent device which detects IR Rays emitted by Human Body and controls the ON-OFF operation of electrical loads. The Electrical Loads can be Lights, Fans, Air Conditioning Units for Energy Saving Application or Siren, Buzzer along with Lights for Security Application. When it detects human movement within its detection area, it automatically turns ON the load. The Loads Continue to be ON till the time Human Movement is detected. The Loads are turned OFF after preset time delay if no movement is detected within the set time. It has an additional in built photo sensor (dusk to dawn sensor) which can set the sensor to turn ON artificial light only when the ambient light condition (LUX Level) drops below the set value. This reduces the large amount of energy wastage and helps in making the most energy efficient lightings along with security.   TECHNICAL SPECIFICATIONS: Operating voltage range: 140V AC to 270V AC Overvoltage/Under voltage protection DC 12 V/24 V versions are also available*** PIR Sensor: Dual Element Pyro Electric Sensor Time setting: Min 30 sec to Max 30 min to turn OFF loads after the last detected motion. Default time is 30sec. LUX setting: Additional Photo Sensor (Ambient Light Sensor) to select the control on electrical loads during DAY Light, PARTIAL Light and NIGHT condition. Current capacity: 5A/ 1000 W- Resistive load, 200 W of Fluorescent Tubes/LED Light load. For AC Control Use Additional Contactor of Suitable Rating. Sensor warm-up time: 1 Minute Sensing angle: 140 degrees Sensing distance: 10-14 Meters Operating Temperature: -10oC to 50oC Protection class: IP55 Enclosure is protected from environmental conditions that are water and dust. EMI protection: Protection against electromagnetic interference noise caused by cell phones, TV, tuners, audio players. Over Current & Short Circuit Protection by an external replaceable fuse In built Protection circuit for lighting loads Provision for Dry Contact Output Terminal available RELAY- NO/NC/COMMON ***

We are offering pir sensor with direct switching. Directly switches on light when it is dark and human motion is detected. Max. Load : 100 watts ambient light intesity trigger level : can be adjusted as required. On time after triggering : settable from 15 secs to 5 min. Metal mounting clamp provided.

Our passive Infrared Sensor is Very Popular for Its Customer Specific and Premium Quality Standard. We Collect Our Passive Infrared Sensor from Market Leading Brands. We Supply the Product all Over India to Cater the Needs of Our Customers. Our Passive Infrared Sensor is Available At An Affordable Market Price. the Product is Used for Measuring Infrared Light that Radiates from Objects in Its Field of View.

• Country of Origin: Made in India
• Brand: Gaurav Engineers
• Sensing Angel: 120 Degree
• Voltage: 230 V AC
• Sensing Range: 35 Feet
• Frequency: 50 Hz
• Packaging Type: Box

• Type: Pir Sensor
• Application: Automobile Use, Industrial Use
• Color: Black, Blue, Red, White
• Condition: New, Used
• Application: Basements, Corridor, Energy Saving, Garage, Lockers, Near Gate, Parking Area, Safe Roo
• Warranty: 1year

• Type: Pir Sensor
• Application: Automobile Use, Industrial Use
• Color: Black, Blue, Red, White
• Condition: New, Used
• Application: Security
• Power: 15w, 20w, 25w
• Warranty: 1year, 2years
• Alarm Range: 1.5mtr, 1mtr, 2.5mtr, 2mtr

• Voltage: 220-240V/AC 50/601/n
• Features: Equipped with integral relay , Compact size ,Electric operated ,Simple design, Durable, Longer serviceability.
• Rated Load: 500W

passive infrared sensor, photo sensor, Occupancy Sensor, Infrared Sensor

PIR Sensor HC - SR501, Lipo Battery, soldering gun, Industrial Robot Wheel

passive infrared sensor, Float Switch / Fluid Level Controller

passive infrared sensor

Passive IR Sensor, Smart Card, MIfare Classic 1k Card 13.56MHz, L298 IC

Independently Intelligent Alarm PIR Sensor, GITO m2 fitness band