Ravjeet Engineering Specialities Private Limited Bhosari, Pune, Maharashtra

Contactless & high resolution measurement High EMC & ESD stability Solid housing & complete sealing Protection class IP 68 & completely sealed Rotational direction recognition high rotational speed robust not sensitivity to dust

This is an Omniversal Chamfering, Pointing, Pointing With Radius, rounding & crown chamfer for Internal & External Gear or Spline. It can even chamfer helical & straight gear & half chamfer for RH or LH Ring Gear. This Machine is a must for Production Shop Prototype gears, pre production batch and small gear shop manufacturing variety of gears and spline.

Double Flank gear rolling test is generally included in final acceptance test. A gear tested on Double Flank Gear Tester is normally the indication of good running properties of the gear and is adequate assurance about the quality of gear. The readings taken are the validation of center distance between two gears to be inspected or between one gear and one master gear meshing without backlash during one complete rotation of gear

These Cutters are very useful for lay shaft cluster gears. Two gears can be chamfered and deburred in one operation saving one loading and unloading and chamfering and deburring time.

DGB is a system to remove nicks & burr for heat-treated gears. DGB is the only system that makes economic sense. DGB cannot make a bad gear good but can make a good gear better by removing its nick & burr. COST EFFECTIVENESS DGB does not require a major capital investment. Any small gear shop with good volume can justify the cost. Even though DGB tool will last through thousands of components, the life will depends on a variable, the amount of nick and burr it has to remove. User can run 100% gears through the process and check on sampling basis. This increases master gear life, improves time and gives constant quality of gear.

These Cutters work like a Rotary Shears. These are held against the sides of faces of the gear. The variation in the width of blank is taken by spring loaded blades. Deburring Cutter remove burrs neatly. These are resharpenable and give very long life.

These Cutters have alternate Chamfering and Rolling Profile teeth. This type of Cutter does not produce any secondary burr on tooth flank. These Cutters are must if gear are directly honed. Even if gear are shaved the life of shaving cutters improve between re-sharpening.

These Cutters have a Master Rolling Gear in the center of a pair of chamfering blades. These Cutters Roll the Profile and eliminates the subsequent operating such as shaving etc. on two wheeler gears.

Self centering tool make equal chamfer at both end. Rolling type tool looking like a shaping Cutter gives better tool life. Tool construction compensates for width variation of face up to 0.20 mm. Automatic tool hunts if gear does not engage with tool. The machine has two slides, one horizontal slide for chamfering operation & one vertical slide for deburring operation. After setting, the cycle is automatic i.e. only loading unloading is manual

These Cutters have teeth like Bevel Gear, Meshing with the Gear produce chamfer by Rolling Process. RAVJEET Cutters have special Strong profile. The Cutters is not Accident Prone & give long life.