Voltmeters Dealers in Akurdi, Pune

• Open Circuit Voltage: 0to5KVOR0to 10 KVAC. The above voltage can be continuously varied from zero to full value and is continuously monitored by Analog/Digital Panel meter.
• Test Current: 2 mA to 20 mA OR 3 mA to 100 mA
• Accuracy of Reading Power: ±2%
• Requirements Safety: 230 volts AC, ± 10%, 50/60 Hz
• Precautions: Voltage on test terminals. High Voltage on test jig appears only after the variac is set to zero and gradually increased. There is a trip device to trip if the current increases than the required value
• Trip settings: The tripping can be reset by a pot which can be varied as peruse requirement
• Open Circuit Voltage: 0 to 30 KV OR 0 to 100 KV AC. The above voltage can be continuously varied from zero to full value and is continuously monitored by Analog/Digital Panel meter.
• Test Current: 5 mAto 50 mA OR 10 mAto 100 mA
• Accuracy Of Reading: ±2%
• Power Requirements: 230 volts AC, ± 10%, 50/60 Hz
• Open Circuit Voltage: 0 to 5 KV or 0 to 10 KVAC. The above voltage can be continuously varied from zero to full value and is continuously monitored by Analog/Digital Panel meter.
• Test Current: 2 mA to 20 mA OR 3 mA to 100 mA
• Accuracy of Reading Power: ±2%
• Requirements Safety: 230 volts AC, ± 10%, 50/60 Hz
•  : Protection provided with zero start to prevent accident availability of High

Pen Phase Sequence Indicator and Conformity TestThe HT70 pen voltage detector permits both to quickly verify the presence of AC voltage on any type of electrical installation (sockets, cables, fuses, switchboards, etc.) with and without direct contact and also to perform phase sequence indication and conformity test on generic three phase plants by using red and green fixed and blinking LED indications. HT70 is designed according to IEC/EN61010-1 safety standard in CAT IV 1000VFunction • Detection AC voltage from 100V to 1000V to ground• Phase sequence and conformity test with 1 wire method• Working frequency: 50/60Hz• With a without contact measurements• LED red and buzzer indication• Practical pen clip• Safety: IEC/EN61010-1, CAT IV 1000VStandard• Batteries• User manual• EMC 2004/108/CE Directive• CE MARK• LVD 2006/95/CE Directive

• Condition: NEW
• Feature: Automatic DCV, ACV, & Continuity Selection, High input impedance & Auto Hold, Auto Power Off

• Brand Name: CDIL
• Colour: Black
• Minimum Order Quantity: 1000 Piece
• Regulator Type: Linear Regulator

Static Voltage Regulator, E Series Generator, Water Cooled Generator

Automatic Voltage Regulator

Automatic Voltage Regulator, Inverters, Ups

Voltmeters, analog switches, portable meters, Frequency Meter, power meters