Back Back
Wall Cabinet Hanging Bracket
60 Per Pair
1000 Pair (MOQ)
3D CABINET BRACKET WITH 'Z' PLATE : This high specification cabinet hanger has a robust plastic case with a metal mechanism inside. This allows easy adjustment even if the cabinet is loaded. Both adjustment screws face the outside of the cabinet for accessibility. The hanger should be positioned tight up to the top panel and against the back wall. It is normally fit into the backboard groove, when using with a solid back. Installing screws are not included. These brackets do allow for flush fitting of units. Check the level for where you wish to fit the units and mark that level on the wall. Mark the inner vertical side of the unit. Drill the wall and screw the wall bracket to the wall. Fit the hangers to the inside upper corners of the unit. Hook the hangers over the brackets and adjust the screws on the white block as shown in fig.contact hanfas for detail they do allow the cabinet to fit flush to the wall. This is achieved by using two adjustable screws on the white block, One in under the block the other is at the back of the block. These help the block to adjust in and out and up and down. On the side of the cabinet there is a hook system which screws to the back of the cabinet. There are brackets which screw onto the wall. The hooks locate onto the brackets and an adjustment from the hook system will tighten the cabinet to the wall. 1 pair is suitable to hang 1 wall unit upto weight of 55KG. 3 'D' Cabinet Bracket: WALL HANGING CABINET BRACKET Loading capacity is 55 KgPc 3-D adjustment of Wall Cabinets Z-axis Depth upto 15 mm X-axis Lateral upto 25 mm Y-axis Height upto 19 mm payments 100% advance
