DECG International Mandideep, Raisen, Madhya Pradesh

The Strip Seal Expansion Joint System consists of a rubber gland, mechanically tightened between two steel edge members and provides a superior watertight proofing system. The design of the DECG Strip Seal System can easily accommodate the high loads of vehicular traffic while effectively sealing joints in bridges and structures with very high movements up to 120mm it is to be noted that IRC recommend strip seal joint for movement up to 80mm. DECG Strip Seal Systems can be manufactured to accommodate a variety of field configurations along with multidirectional movements. The DECG Strip Seal has been engineered so that the elastomeric Seal can be inserted either prior to or after the securing of the steel shapes to the superstructure. Machined Steel shapes maximize Seal install ability and minimizes manufacturing tolerance.

Country of Origin : India

Type : Strip Seal Expansion Joint

Material : Stainless Steel

Application : Bridge Use, Construction

Feature : Heat Resistant, High Strength, Leak Proof

Finishing : Polished

Certifications : ISI Certified

Spherical bearing, also called spherical bridge bearing spherical bearing also can be divided into three types: fixed spherical bearing, guided spherical bearing and free sliding spherical bearing. With high strengthened steel body, spherical bearing is especially designed for high vertical, horizontal and lateral loads and where large rotational structural displacements need to be accommodated.

Pot PTFE bearing consists of a metal piston supported by a disc of unreinforced elastomer that is confined within a metal cylinder for allowing rotational movement about an axis in the horizontal plane and to bear and to bear and transmit vertical load. Pot bearings may be provided with sliding assembly (with or without restraint in the form of a guide along the desired direction to bear and transmit horizontal force) comprising of stainless steel plate attached to metal backing plate sliding in a horizontal plane over sliding material confined in recess(s) on the piston which shall be termed as sliding/Guided Pot bearings. Depending on the desired degree of freedom Pot bearings may be of three types as follows:

Pin bearing consists of a metal pin attached to a metal cylinder to bear and resist horizontal force along with all directions on the vertical plane and facilitate rotation movements about any Horizontal axis. The pin bearing does not bear or transmit any translational motion.   Pin bearings are not structurally complex and do not resists any vertical loads. It is one of the most common fixed bearings used in bridges.

Country of Origin : India

Material : MS

Warranty : 2 Year

Condition : New

Elastomeric bearings are elastomers manufactured from synthetic and natural rubber. These bridge bearings support both translational and rotational movements through elastomer deformation. Elastomeric bearings can carry large loads and prevent lateral bulging of the elastomers. The number of elastomer pads needed for the construction depends on the type of reinforcement used for the bridge. For instance, steel reinforces elastomeric bearings are the strongest, and plain elastomeric pads are the weakest. One of the best things about Elastomeric bridge bearings is that they are neither expensive nor require any maintenance after installation