Plastic Coatings in Shapar, Rajkot

• Finish: Flat
• Colour: White, Clear & Gray
• Clean – Up Thinner: Soap and Warm Water
• Sp. Gravity: 1.4-1.5
• % Age Solid: <65
• Flash Point: None
• Practical Coverage: 60-100 sq. Ft/gallon, depends on the surface, method of application and the thickness of the film.

A premium quality 100% Acrylic elastomeric coating specially formulated for waterproofing to form a seamless membrane, which is resistant to sunlight, heat, water and most chemicals, typically used as waterproofing and as a topcoat for roof coating to protect the UV rays for reducing heat at bottom. It provides superior protection to built-up and gravel roof systems, may also be used on galvanize steel, concrete and urethane foam roofing, it gives outstanding durability because of its UV protec Features Forms a flexible coating that protects against UV rays, Heat and pounded Water May also used on metal, wood, Concrete and Masonry Surfaces May also used on Galvanized Steel Surface Preparation Surface must be clean, dry and free from dust, grease, mildew and wax remove any loose and peeling parts and prime with America’s colour primer. If surface is glossy should be sanded to a dull finish If mildew is present the surface should be washed with chlorine bleach solution (20% household bleach and 1% liquid detergent in warm water) If Concrete is new then allow for 30 days prior to application The PH of Concrete should be less than 10, check by PH paper, if Surface is not within the 10 PH and large amount of efflorescence. (efflorescence is seen as a white salty deposit on the concrete surface) are present then the concrete should be acid etched prior to painting ( etching solution is 1 part of commercial HCL and 3 parts of water mix) and apply uniformly the wash with clean water and allow to fry the surface. The Concrete must be dry prior to coating (less than 12% moisture content) but f the surface is totally dry then spray little water on the concrete prior to painting will help the paint to penetrate into the concrete. Latex base sealer or Primer must be applied first to reduce the exposure to alkali conditions

Epoxy Polyester Powder Coating, Powder Coating Powder, Powder Coating

Frp Lining, Air Ventilator, plain sheets, erp door, bath tubes

high temperature refractory coatings, Binders Foundry Coating

Epoxy Polyester Powder Coating, Epoxy Powder, epoxy polyester powder

Paints, Water Based Paints, designer paints, Wood Coatings

power coating, Powder Coating, plastic coating, polyethylene coating

Powder Coating, Auto Parts, Casting Parts, Aluminum Casting Parts