Adhesives,Glues and Sealants Dealers in Ranipet

Coal Tar Modified Epoxy (Ultrapoxy-CTE) is a high build two pack waterproofing and anticorrosive system based upon epoxy resin, coal tar and amine curing agents. These agents in Coal Tar Modified Epoxy (Ultrapoxy-CTE) are specially chosen for their ability to withstand high degrees of corrosion and also for mild chemical attacks. We offer Coal Tar Modified Epoxy (Ultrapoxy-CTE) at the most competitive prices in the market. Features / Advantages Easily applicable by brush or trowelSeals localized cracks and surface porosityBonds strongly to most of the building materialsNo primer is requiredCures to a tough elastic waterproof filmExcellent resistance to chemical aggression Typical Applications Protective, waterproofing system for building roofsAnticorrosive coating for mild steel structures Technical Information Nature : Two-component LiquidColor : BlackMixing ratio part by weightPart I (B) : 90Part II (H) : 10Solid content: Part I : 65%Pot life at 30oC : 3 ½ - 4 hoursInitial hardness at 30oC : 24 hoursFull cure at 30oC : 6 to 7 daysCoverage : 30-35 sq. ft. / literRecoat ability : 12 hours Below 20oC these timings may be increased Direction for use Surface Preparation : It is essential that Coal Tar Epoxy is applied to clean dry substrate in order to achieve maximum adhesion between the coating and substrate. All loose particles should be removed by brushing scraping or acid etching.Mixing : Coal Tar Epoxy is supplied in pre weighed packs which are ready to use on site. DO not add extra solvents or thinner, thorough mixing is essential.Cleaning : Tools and equipment can be cleaned immediately with solvents like xylene, acetone etc.Storage and Shelf Life : 12 months shelf life if stored below 35oC and 50% R.H. Packing 1 liter5 liters20 liters Direction for use Bare Steel : All surfaces shall be free of rust, mill scale, and contaminants such as oil, grease, dirt, and salts. Before any surface preparation is attempted, oil and grease must be removed by employing SSPC- SP1 solvent cleaning. Precaution Danger!Flammable!Contains xyleneKeep away from heat, sparks and flame. Avoid breathing vapor.Use with forced air ventilation in confined areas.Avoid contact of resin or hardener with skin or eyes.In case of eye contact, flush immediately with plenty of water and consult a physician.Do not take internally.Not to be applied when air and surface temperatures are below 50oFMust be top coated with appropriate coating when used in corrosive environmentsCaution when opening containers- gassing may occurNot for immersion or for exposure to acids & alkalis without proper topcoats

Animal Glue, whiteners

Adhesives, Adhesive Tapes, Packaging Material, Polythene Roll

wax emulsion

Adhesive Chemicals, upholstery, Clear Varnishes, upholstered sofa