Birla White Wall Putty Dealers in Chorhata, Rewa

Velvet wall putty is white cement based fine powder which provides an ideal finishing for concrete / cement plastered walls and ceiling.   Application Data   Surfaces to be painted.   New surface requires preparation such as removal of dust, dirt and foreign matter, In cases of cracks, voids & damages it should be repaired. If surface plaster was rough, 1st apply white cement/ white cement mortar and level the surface. cure the surface for 2 days. before starting putty coat. surface should be in just-wet condition, prior to putty application.   CAUTION : Not recommended over lime wash.   Primers Not required.   Methods of Application   Mix Velvet wall putty slowly in 35-40 % water by volume to prepare paste of desired consistency. Mix vigorously for 5-10 minutes for making lump free and uniform paste. Product should be mixed in such quantities that is could be used within 2 hrs of its preparation. Mixing could be done manually or by suitable electric mixer.   Finishing Use spatula /blade/ trowel on the wall with "bottom to top" configuration. Apply second coat preferably after 4 hrs in hot season & after 12 hrs in cold season. Second coat shall be applied "horizontally" to even out application marks of 1st coat if any. Re-mix putty paste again for 1 minute, if it is left un-disturbed for 30 minutes. Allow complete drying for 3 days and then use fine emery paper to remove application mark, if any.