Paint Dealers in Rewa

Velvet wall putty is white cement based fine powder which provides an ideal finishing for concrete / cement plastered walls and ceiling.   Application Data   Surfaces to be painted.   New surface requires preparation such as removal of dust, dirt and foreign matter, In cases of cracks, voids & damages it should be repaired. If surface plaster was rough, 1st apply white cement/ white cement mortar and level the surface. cure the surface for 2 days. before starting putty coat. surface should be in just-wet condition, prior to putty application.   CAUTION : Not recommended over lime wash.   Primers Not required.   Methods of Application   Mix Velvet wall putty slowly in 35-40 % water by volume to prepare paste of desired consistency. Mix vigorously for 5-10 minutes for making lump free and uniform paste. Product should be mixed in such quantities that is could be used within 2 hrs of its preparation. Mixing could be done manually or by suitable electric mixer.   Finishing Use spatula /blade/ trowel on the wall with "bottom to top" configuration. Apply second coat preferably after 4 hrs in hot season & after 12 hrs in cold season. Second coat shall be applied "horizontally" to even out application marks of 1st coat if any. Re-mix putty paste again for 1 minute, if it is left un-disturbed for 30 minutes. Allow complete drying for 3 days and then use fine emery paper to remove application mark, if any.  

Paints, Aluminum Section, Wall Putty, Wall Paints

Paint, Ms Pipe, gi pies

Paints, Pipe Fitting, Sanitary wares, Wall Paints, water tapes