Power Factor Controller Dealers in Sangli

We are offering automatic power factor controller. Certain elctricals loads such as motors found in heavy machinneries ,can cause the electrical system to be highly inductive. This result in poor power factor . Poor power factor means higher energy losses which ultimately get converted into large electricity chrges. A simple solution to this problem is to balance this inductive load with equivalent capacitive load . Tis is achieved by connecting or disconnecting the capacitors to or from the system. Manual switching of these capacitors is not possible in case of rapidly fluctuating loads . So even in an environment of rapidly fluctuating loads to achieve the required power factor one may need an automatic power factor control device, called automatic power factor controller, to connect and disconnect these capacitors. Sycon 66 xx e3 controller is an automatic power factor controller used to control the power factor of the system . It can sense the powre factor of each individual phase in the three phase system and can switch the capacitors according to the requirement.

• Phase: Single
• Frequency: 50 Hz
• Brand: Sycon
• Model Name/Number: SYCON 6616
• Display Type: LCD Display (2x16 character)
• Input Voltage: 415 AC-15%
• Current Input: 5 A, 1 A (optional)
• Over Voltage Release: 470 V AC -1%
• Low current: 1% (50mA)
• Switching Contact: 10A at 250V AC
• Accuracy: Class1
• Switching Interval: 5-1200Sec
• Dimensions: 144 (L) x 144 (W) x 80(D) mm
• Panel Cutout: 138 mm x 138 mm
• Weight: 1.6Kg

• Brand Name: SYCON

We are offering automatic power factor controller. display parameters power factor capacitor stages onoff discharging capacitors voltage, current kwkvakvar shortfall or excess kvar % thd selectable display of 3rd to 13th harmonics selectable display of capacitor values display of settings display of alarm message features intelligent with best fit control stages 4 to 16 menu driven user friendly handling alarm output easy to install control password protection for settings adjustable %kvar switching capacity adjustable value of target pf adjustable ct ratio from 1 to 1250 adjustable time delay from 1 sec for switching on insteps for 1 sec models available in 4,6,8,12,14,16 steps adjustable settings for % thd (total harmonic distortion) protection disconnection in case of low current adjustable number of maximum stages. adjustable lock time for power on auto identification or manual feeding of capacitor values manual switching facility test mode facility modbus communication (optional).

Features RISC Microcontroller based field proven design Three digit PF display Individual Stage LED indications Indication range from 0.5 lag to 0.5 lead User settable High and Low set points also in three digit User settable bank on time, bank off time, bank discharge time Settable Cyclic or FIFO switching sequence Settable No Load Compensation (NLC) For Transformer Auto or Manual Mode Selectable from outside switch For all settings the controller is protected by a password to avoid unauthorized access. Test mode for testing the wiring logic when there is no load current. Input voltage from phases R & Y Input Current from phase B CT All Electrical Connections on rear side Potential free relay contact outputs to operate the banks Relay contact rating is 5 amps at 230 VAC