Test Rig Dealers in Ganapati Peth, Sangli

• Weight: @ 150 Kg
• Space Required: 1.5 m. (L) x 1.0 m. (W).
• Service Required: Power Supply : 230 V. A.C., 50 Hz.

Range of Experiments: To study all components used in refrigeration system. To study the Vapor compression Refrigeration cycle. To determine the Refrigeration Effect, Work Input, Actual C.O.P., Carnot C.O.P., Theoretical C.O.P., Relative C.O.P., Ton of Refrigeration, and Plant Efficiency. Experimental Setup : Compressor - Hermetically sealed compressor. Condenser - Air Cooled condenser made out of copper pipe & Aluminum fins of matching capacity with fan cooling. Evaporator - Copper Coil immersed in water. The evaporator is insulated from outside to prevent heat loss. Expansion device - Capillary Tube & Thermostatic expansion valve. Energy Meter - One each for power measurement of compressor & evaporator heater. Pressure Gauge - 2 Nos. for H.P., L.P. measurement Suitable filter/drier. Hand Shut Off type Service valve. Dimmerstat to control power supply to heater. Rotameter for Refrigerant flow measurement. Immersion type electric heater. Solenoid valve Castle Italy make. Set of thermocouples.   Control Panel : 12 Channel Digital Temperature Indicator HP-LP Cutout - Make Ranco /Danfoss or Equivalent. Switches - For compressor, condenser fan, solenoid valve & evaporator heater. Voltmeter - 0 - 250 V. Ammeter - 0 - 15 A. 6. Thermostat : Ranco or equivalent

Calibration of orificemeter, Venturimeter & Rotameter Test Rigs(Closed circuit system)      Venturimeter 1” size having 13 mm throat diameter with 2 G.M. valves  Orificemeter suitable for 1” size pipe line & d/D ratio is 0.6 with 2 G.M. valves  High precision properly calibrated rotameter suitable for 1” size pipe line having 4.2 to 42 LPM capacity  M.S. / G.I. piping system for mounting the Venturimeter & Orificemeter Each pipe having the pressure tapings with separate cocks connected to a common middle manifold which is connected to the manometer & G.M. gate valve  M.S. reservoir with gauge glass & scale fitting, drain valve of ½ ” size & a bend  M.S. collecting as well as measuring tank with bypass arrangement & drain valve of 1” size. A gauge glass & scale fitting are fitted on measuring tank for discharge measurement  1 m height double column differential manometer (without Mercury)  1 HP high head monoblock pump for water circulation  Strong iron stand to support the unit  Entire unit is powder coated with good colour combination  Instruction manual 1 copy

Pelton turbine test rig of blower casing fitted to a variable speed motor. Three different type of impellers can be fitted over the shaft. Air discharge is measured by venturimeter. The impeller can be rotated at different speed and performance of blower can be estimated at different speed and discharge heads.

compression test rig, Test Equipments, spring endurance test rig

disel engine test rig, Petrol Engine Test Rig