Laboratory Equipment Dealers in Satara

The apparatus consists of a variable speed D.C. Motor. Driving Pulley and Driven Pulley of equal diameters. The pulleys are mounted on input shaft (motor shaft) and output shaft. The Driven pulley can slide on the base only with bearing block to change the initial tension in belt. Brake Drum is mounted on the output shaft, which helps to measure power output. The motor speed is varied by Dimmerstat. Driving and Driven pulley speeds are indicated by a two channel digital Speed Indicator. With the help of Stroboscope it is possible to demonstrate the slip of belt on Driving and Driven Pulley. SPECIFICATIONS • D.C. Motor- 1 HP, 1500 RPM, 230V variable Speed • Driving and Driven Pulleys of equal diameters (flat pulleys) • Brake Drum along with spring balance and rope arrangement is provided to load the system. • Flat belts of fixed length of following belt material.      • Fabric Belt      • Canvas Belt • Rubber Belt • Belt tightening arrangement - Bearing block is sliding and dead weight can be applied to   set the initial tension in belt. • Speed Indicator: Two channel digital speed indicator with switch to change the channel. EXPERIMENTATIONS • To measure co-efficient of friction between pulley material and different belt materials • To measure power transmitted with varied belt tension and plotting a graph of    (T1-T2) V/S (T1+T2) i.e. "Tension Characteristics". • To measure percentage slip at fixed belt tension by varying load on the Brake Drum and    plot the graph of (T1-T2) V/s percentage slip i.e. ‘Slip Characteristics’. Finding a    Creep Zone from graph. • To measure belt slip speed and observe the limiting value of load at constant speed    when the slip just starts. SERVICE REQUIRED- • Single Phase 15amp Electrical Connection.

The ‘J.P.T.I.’ unit consists of a three slabs of different materials namely mild steel, wood & Bakelite. Nicrome heater is provided to supply heat input across these composite walls. Total heater assembly comprises of a heater bound between two aluminium plates, on both sides of this heater identical structures of composite wall are placed. Thermocouples are provided at proper position in the composite wall to record desired inside temperature of composite wall. Multichannel temperature indicator is used to measure this temperature. Small hand press provided to press the wall on each other & to ensure that no air gap remaining between two plates. Heat input to heater is given through a variance & measured by voltammeter & ammeter. By varying heat input & combinations of the composite structure wide range of experiment can be performed.

The 'J.P.T.I.' unit consist of flow channel of proper length & width. The notch is fitted, water supply is given at one end of channel. Water flow over notch . Arrangement are made to measure the still level to determine the head.

Specifications Models V30 / V36 / V40 Screen size 300 / 360 / 400mm Choice of work stage Traverse X & Y axis Choices of telemetric lens 10X / 20X / 50X / 100X with index able turret to hold 3 lens Vertical traverse 100mm with motorized movement Size of table 170*170mm 300*150mm 400*200mm 400*300mm 25*25mm micrometer 150*75mm 200*100mm 275*175m

• Voltage: 110V, 220V
• Feature: High Performance
• Condition: New, Used
• Warranty: 1yr, 2yrs, 5yrs
• Certification: CE Certified
• Color: Silver, Black

Strainer, column pipe, motor stool, Moulding Box

Digital Ecg Machine

Automation Products, Electronic Tourniquet, Programmable Logic Controller

hydromat peristaltic pump, pneumatic intracorporeal lithotripter

Acupuncture Apparatus, Vascular Surgery, Blood Bank, kidney transplant

lime chemicals, Instruments

Ecg Machine, Operation Theatre Light

Strainers, forge steel ball valve, Gauge Cock, Pipe

Soup Strainer, Flour Sifter, steel cover