Automatic Shrink Wrapping Machine Dealers in Thane

These systems are available in a very wide range with respect to product and pack sizes. As all our machines are custom built to suit individual clients requirement, these machines can & have been manufactured to shrink wrap even very large size products like Jumbo Paper Reams (L - 46" x W - 30") and also Double Bed Mattresses.   However, most products like bottles, tins, cans, boxes, containers in small configuration of 3 x 2 = 6 Nos or 5 x 2 = 10 Nos with / without base tray (depending upon product) can also be Shrink Wrapped at speeds ranging between 12-17 packs per minute.   Machines are available with options of Sleeve Wrapping (i.e. two sides open) or with Partial `U' Sealing whereby the pack is completely enveloped from all six sides, the front & back are trim sealed and sides are partially sealed.   Also available are `L' sealers and Overlap sealers for products which are low profile in height and require to be all side closed.   All the salent features mentioned in point no 1 are also prevalent in this system.

• Size: 20” X 16” X 16”

Total machine body will be made in M.S. control panel given for websealer and shrink machine.LDPE Shrinkable Film Roll of Single Layer 70 TO 90 microns 550mm width.1 no PMDC motor, 1 no Gear Box, 1 no Speed Drive, 1 no AC Blower Motor, Variable Speed approx 5 to 8 job per minute.

Semi Automatic Shrink Wrap Machine is more suitable to any form or type or design like box, bottles irrespective of shape. The semi automatic shrink wrap machine is more suitable for low speed production lines for both pharma and food industries and for other respective applications. The required collation and matrix forming will take place on collation plate which placed near to web sealer section. Once the required matrix formation gets completed ,manually push the matrix pusher on to  welding area and take back the pusher . The delay signal gets activated by sensor and gives the signal to  seal bar accordingly seal bar comes down and sealing and cutting operation gets completed After the sealing and cutting operation seal bar ascends, the manual pusher advances to transfer the  collation into the welding position, at the same time displacing the previously wrapped collation onto continuously moving shrink tunnel conveyor. The wrapped collation soon enters the shrink tunnel chamber where recirclulated hot air causes the wrap to shrink and tightly conform to the contours of the contents. Once the pack is out of the hot chamber , forced air cooling is used to tighten sleeve wrap to achieve a strong, secure pack ready for stacking on pallet or a placing on a shipping carton.

• Specialities: Eliminates the need for paper box to cushion the bottom of products being packed.

We offer a comprehensive range of fully automatic PLC based shrink wrapping machines, which is used in shrink wrapping applications across industries. Available in fully automatic operational specifications, we can also customization our range to meet specific requirements of our clients. These PLC based shrink wrapping machines are used for packaging of number of products. Big single products.ther will be one roll on top and another roll on bottom. Both roll will be sealed manually , then put into automation . product will be pushed one by one through the film and will be sealed , and will enter into shrink tunnel automatically, for skin tight wrapping finish.

We are engaged in manufacturing and supplying of automatic shrink wrapping machine.

Automatic Shrink Wrapping Machine, Blow Moulding Machines