Electronic Test Instruments Dealers in Charai, Thane

CX-401 measures : pH, redox potential (mV), conductivity, resistivity, salinity in KCl or NaCl, TDS, dissolved oxygen in % of saturation or in mgl, atmospheric pressure and temperature. “HOLD” function to freeze the result on the display. Signalisation of the result stabilisation “READY” with symbol and sound. Possibility of sending to a PC a report of calibration - up to 10 last calibrations. The meter may be used for the field measurements as well as during accurate laboratory work. The meter is equipped with an easy-to-read back-light LCD display with brightness control. All functions are distinctive by very high accuracy and repeatability. Unification of the operating procedures in all measuring functions makes working trouble-free. Low weight and small size make working in the field easier. Waterproof housing (IP-66) enables working in difficult conditions.

• Display: 16 X 1 Alpha-numeric LCD Display With Backlight
• Models: P-181 or. F-181
• Type of Meter: Insertion Paddle Wheel type Velocity Meter
• Max. % of Solids: 1% of fluid volume, non-abrasive, non-magnetic, <100 micron in dia. & length
• Mounting: Field or, Panel
• Pressure drop: Less than 0.1 bar
• Pipe Line Size: Min. 15 Mm Up to 500 Mm
• Pulses: 4 Pulses each rotation
• Accuracy: +/- 1% of Full Scale if velocity is more than 0.5 m/s
• Repeatability: +/- 0.5%
• Linearity: +/- 2% of full scale
• Enclosure: Weather proof IP 65
• Gland: PO7
• Fitting Material: ABS, SS304 or, SS316
• Fitting Type: Threaded, Flanged, Weld on Adaptor
• Velocity Range: From 0.5 to 5.0 Mps
• Max. Operating Temperature: 60°c for Pp Sensor with Abs Fittings & 100°c for Ss Sensor with Ss Fitting
• Sensor Cable Length: 0.5 mtrs for Field Mounted Meter & 3 mtrs for Panel Mounted Meter
• Paddle: PVDF (Magnetic up to 100°C & Non Magnetic up to 80°C)
• Indicator Housing: Polycarbonate
• O-rings/Pin: Viton / Hastealloy C
• Sensor Rod: PP or, SS316
• Indicator unit dimensions: 110 mm (H) X 110 mm (W) X 150 mm (D)
• Field selectable Units: MPS
• Supply: 230 V AC +/- 15%, 50 Hz
• T Fitting: it is Compulsory with Pp Or, Ss 316 Flow Sensors (selection from Type of T-fittings)

As you must know Rain Water Harvesting - is the activity of collection of water. It can be either store for direct use or can be recharged into the ground. As studied above, while dealing in second part of the definition that – “it can be recharged into the ground”. Resistivity test is the key factor. As we know the underground strata broadly it is - soil then Murom layer next is the Hard Murom & then the Basalt or in some cases it is marine clay & basalt.

Ultrasonic technology (no mechanical moving parts), Accuracy class 2 acc. EN 1434, Manufacturer approval H1 acc. MID (European Measurement Instrument Directive), Energy meter consist of flow part, calculator and temperature sensor, The energy meter shall be calibrated as one unit acc. EN1434, flow sensor for cooling application in IP65 (protected US sensors), max flow rate shall be 2x nominal flow rate (permanent).

• Frequency: 128 Hz
• Measurement Range: Up to 0.1 Ohms
• Accuracy: 2%
• Display: 3½ digit, Low battery indication
• Battery: 12 V 1.5 Ah, rechargeable
• Weight: 1.5 kg
• Dimensions: 225 mm x 150 mm x 75 mm
• Working Temperature: 0 C to 55 C

In order to reduce Broadband and ISDN Line transmission losses, it is essential to check Earth resistance. With this tester we can check earth resistance up to 0.1 ohms. We can also measure soil resistivity. Unit works on chargeable battery. Necessary accessories along with charger are provided with unit. Features Measurement up to 0.1 Ohms Accuracy up to 2% Digital display Generated signal is not in range of harmonics of mains supply to avoid interference Test resistor are provided to confirm calibration Low battery consumption Battery is chargeable maintenance free type Heavy duty accessories provided for proper reading Operation Short left side two terminals E1 & P1 and connect it to point whose resistance is to be measured. This wire should be shortest possible. Connect other 2 wire provided along with unit to other two terminals. Fix the rods at app.10 to 15 meters in different directions. Pour a glass of water on the rod to make good contact. Select 2V range & press test button. Then display will give direct reading of earth resistance.  

3½ DIGIT LED DISPLAY WITH SALINITY CELL AND OTHER ACCESSORIES. Digital Salinity Meter is a precision instrument for potentiometeric measurements. Results are displayed in milli volts on a direct digital readout by light emitting diodes (LED).  

• Brand Name: AVI
• Accuracy: 0.5 percentage of full scale
• Voltage: 240 V
• Application: Laboratory
• Power Source: Electric
• Usage/Application: Laboratory
• Material: SS
• Display Type: Digital

• Range: 250 MM - 3000 MM

A cylindrical Main capsule fitted with powerful magnet, which moves up & down alongwith the level rise or fall. This movement will be magnetically coupled with the follower Red indicator outside the chamber which is enclosed in the glass tube.

digital lcr meter, Lcr Meter, Led Dome Lights

Side Mounted Magnetic Level Indicator, Conical Basket Strainer

battery monitors, battery management systems, Line Of Sight Surveys

electronic microcontroller, Rgb Controller, temperature controller timer

digital earth tester, line testers, board band line testers

Energy Meter, Barcode Label, pressure sensitive labels, Stickers