Nozzle Heaters Dealers in Thane

Anupam's Coil Type Nozzle Heaters are capable of performance under the most adverse conditions. Highly recommended for processing high temperature resins to eliminate premature failures due to burn out/ process material leakage. Heat transfer is based on conduction as well as on radiation principle, which not only improves the thermal efficiency but easy to assemble on nozzles as no pressure on heating surface is essential. Even unskilled operator can fit the heater with no risk of failure of the heater. Coil Type Nozzle Heaters are specially designed to prevent the failures of heaters against the leakage and contamination of plastic material at nozzle position. This heater can meet the higher temperature requirement prior to molding at nozzle position. CONSTRUCTION Stainless Steel Sheath Tubular Heating Elements in Round / Flat Sections are used as Heat Source. Low thermal expansion steel covers with suitable Mounting Brackets houses these Tubular Heating Elements. APPLICATION The Coil Type Nozzle Heaters are typically used to Heat up the Nozzles of Injection Molding Machines.

• Application: Industrial Use

APPLICATION Low cost electric heating of plastic processing, rubber vulcanizing, Drums, Barrels & cylinders etc. CONSTRUCTION Mica insulated Heaters consist of electric resistant ribbon / round wire element covered with zinc plated MS, Brass or SS sheet with clamps. Size & terminal connections as per requirement. CONNECTION For contact accessories, cable fittings, clamping devices, fixed & braided connection, heat resistant, flexible insulation with metal braided cable housing of any convenient length, connection boxes & types according to the band heatersdimensions, power & type of power supply. STANDARD SIZES & CAPACITIES Max. Watt density: Any convenient Wattages up to 25 W/Sq. inch. Max. Surface Temp. 300 Deg. C. Supply (Volt) – Any convenient Voltage under the pre condition that it should be technically feasible

Coil Type Nozzle Band Heaters are specially designed to prevent the failure of heaters against the leakage of plastic material at nozzle. These heaters gives higher temperature(above 250C) at nozzle point which is required for H.D. Plastics such as Nylon,ABS,Delrin  

Manual Aluminum Nozzle Band Heaters, Nozzle Heaters, Immersion Water Heater

nozzel hiter, PP Clamps, Cooling Tower, Air Dryers