R.k.engineering Bhayandar, Thane, Maharashtra

We are offering wire puller is a great tool having 10 mtrs. To 45 mtrs. In size which the electricians use to pull wire trough electrical conduit. A wire puller is thin piece of steel in a flat style that is coiled in predetermined lengths & is referred to as tape.

We are offering flexible bending springs are just a spring made from flattened steel with a taper at one end (which is inserted into the pipe) while the other end incorporates an eye. With the spring within the pipe is prevented from collapsing inwards as it is bent. Internal bending springs are commonly used for (pvc pipe from 12 to 25 mm) external diameter (larger spring are available but are not recommended). A specific spring is required for each size of pipe being bent.

Description internal spring bending internal springs are just a spring made from flattened steel with a taper at one end (which is inserted into the pipe) while the other end incorporates an eye. With the spring within the pipe is prevented from collapsing inwards as it is bent. Internal bending springs are commonly used for (pvc pipe from 12 to 25 mm) external diameter (larger spring § are available but are not recommended). A specific spring is required for each size of pipe being bent. bending with the help of internal spring: internal spring before you start, tie a length of cord to eye on the end of the spring, this will allow the spring to be removed  from the pipe. insert the spring into the pipe so that it is positioned evenly across the area of the required bend. If the spring is a light fit in the pipe, rotate the spring anticlockwise as is it inserted - this will cause the spring to `wind-up' so that it will have a slightly smaller overall diameter. If the pipe has been cut before bending, the end of may have become slightly reduced, don't try to force the spring, but carefully remove the burr so that the spring will freely enter. Some pipe cutters incorporate a vee shaped blade which can be used to remove these burrs. with the spring correctly positioned, the usually method with pipe upto 15mm is to place the center of the bend across the knee and slowly pull both ends to form the band. Slightly over bend the, pipe, then reverse the pipe from the spring and make it easier to remove the spring. For pipe larger than 20mm, some people prefer not to bend around the knee due to the force which needs to be applied. In these cases (or for pipe under 20mm is necessary) the pipe can be bend around anything fairly solid with a curved surface greater than about 100mm (4 inch) radius. if possible, offer up the bend and adjust it if necessary to suit the installation. when happy with the bend, remove the spring from pipe, using the cord and/or rotating the spring anticlockwise as it is withdrawn if necessary.   available in following sizes 3/4" 1"  

fish tape is a great tool having 10 mtrs. To 45 mtrs. In size which the electricians use to pull wire trough electrical conduit. A fish tape is thin piece of steel in a flat style that is coiled in predetermined lengths & is referred to as tape. to be able to pull wire through a pipe, you must first fish the tape through the pipe to the other end; you attach the wires to the fish tape in order to pull them through the pipes. usable tool when job calls larger wire in conduit use this fish tape to poll in row to make a wire pull. Although the steel wire in both stout & flexible. to pull wires with fish tape with one person standing with the fish tape feed the wires, pull evenly on all wires to be fed. Try to keep the wires untangled as you feed them. Feed the wires by lubricating the wires with one hand and feeding them into the pipe, while pulling the off of the wire reels with other. available in following sizes

Wire Puller is used to pull wire from 1 point to another cencil point. It comes with rustless in quality. We take minimum 100 pcs orders, i.e. 1 box as our standard packing.