Speed Switches Dealers in Ayad, Udaipur

(2 products available)
  • PIR Motion Switch

    PIR Motion Switch

    Get Price Quote

    This PIR Motion Sensor is a new type of Energy-Saving light control switch. It works by detecting heat rays emitted by the human body. Auto switching of lights or other fixtures based on human occupancy in residential and commercial buildings. Security systems for triggering of Buzzers or switching on CameraDVR when human motion is detected. TECHNICAL DETAILS : Operating voltage: AC 110-250V 50Hz-60Hz Operating temperature: -20C~+50C Max. Load : 1000W normal Incandescent type Detecting distance: 0~7M (Related to the installation) Detecting angle: 360°(Related to the installation) Time delay: 10 seconds to 7 minutes - Adjustable Light Sensitivity : DayNight sensor - Adjustable Dimensions: 115mm Dia & 55mm Height

    more..
  • Microwave Motion Sensor Switch

    Microwave Motion Sensor Switch

    Get Price Quote

    The microwave sensors is working according to the microwave Doppler effect , it can be widely used in as automatic control switch, the security system, and Automatic video control system of ATM, as well as other automatic induction control area. The Detection way has the below advantages compared with other as follows: 1. Non-contact Detection, 2. Suitable for bad environment, immune to temperature, humidity, noise, air, dust, Light 3. RF interference ability, 4. Transmission power only 0.2 mW, It will not harm the human Body. Simple installation+ easy wiring. We use appropriate micro processing integrator, not Only for high sensitivity and wide range of detection, and on very reliable work, error rate is Extremely low, It can stable working on the temperature range: - 15 ~ + 70 Celsius degrees. Time setting 8sec to 12min (adjustable) Light control2~2000LUX, (adjustable) Power consumption: approx.0.5W Important: persons or objects moving towards the sensor are detected best! Note: • The 220V fire line should be connected with “L”. • The 220V zero line should be connected with “N”. • The loaded fire line should be connected with “L′”. • The loaded zero line should be connected with the 220V zero line of the power source. ## The high-frequency output of this sensor is < 10Mw- that is just one 100th of the transmission power of a mobile phone or the output of a microwave oven

    more..
  • Best Deals from Speed Switches

Filter by Locality
top