Desiccant Air Dryers Dealers in Vadodara

In Desiccant Air Dyers, the compressed air is passed through a pressure vessel filled with an adsorbent media such as activated alumina, molecular sieve or other desiccant material. Two vessels with desiccant are used. The desiccant can bring the dew point of the air down to -40 degrees Celsius or below. This means that the air will not condense water until it is cooled to -40 degrees Celsius. Wet air enters the vessel through a pre-filter to remove any oil and other contaminants which protects desiccant’s long life. Pre-filtered air enters into adsorption tower through solenoid valves controlled by an electronic timer. In practice two vessels are used; one vessel is drying the air, while in the other the moisture absorbed by the adsorbent in the vessel is being regenerated. After a pre-determined period of time the switching of the vessels takes place with the help of the electronic timer. The other absorber tower undergoes regeneration with a portion of dry air exits from adsorption tower. This regenerated air is purged out of the system. Features & Advantages Low Maintenance Cost No heater Required Electronic Timer for Reliable and Continuous operation Fully automatic Wall mountable models also available

SIGMA-Dry Made from activated aluminium oxide, the desiccant has an exceptionally high adsorption capacity and its regeneration capability provides sustained low pressure dew point performance with minimal pressure loss. The desiccant is also waterproof and mechanically stable, which makes it particularly suitable for long periods of operation. Furthermore, specific pellet sizes are available to ensure optimal performance of flow diffusers and sieve plates. Air Flow Rate : 0.15 to 154.53 m³/min (5 CFM to 5457 CFM)

• Volatage Frequency: 230V AC, 50/60HZ
• Power Consumption: 60 Watt
• Protection Class: IP 65
• Filter (Inlet): 10 Micron
• Filter (Outlet): 5 Micron
• DP Based Control: Optional

  PURGELOSS of 10% is reduced up to 5% by integrating online dew point transmitter to the Sequential programmer. Drying Tower changeover takes place when dew point goes down the desired limit which results in huge saving of purge air. Salient Features Simple design filled with Activated Alumina as drying desiccant Capacity from 25 SCFM to 2500 SCFM Dew Point Range (-) 40 to (-) 60°C Pressure Range 5 to 15Kg/cm2g Power consumption is only 60Watt to operate Solenoid Valve Long Desiccant Life Low initial cost & operational cost Requires no maintenance Skid mounted modular design Application Chemical Pharmaceutical PneumaticTools Painting Booth Pneumatic Control System Automobiles    

• Voltage: 440V
• Body Material: Stainless Steel
• Frequency: 50Hz / 60Hz
• Phase: 3 Phase
• Power Source: Electric
• Usage: Industrial

desiccant type compressed air dryer, Gas Generators, micro filter

automotive drain valves, engineered adsorption dryers, Air Cooled Aftercooler