Multi Mill Dealers in Vadodara

For the convenience of the clients, we have adopted safe and secure payment gateway that helps us in the attainment of complete client satisfaction and maintaining transparency in dealings. To pack our products, we have ultramodern machines. The packaging materials are nontoxic, sturdy and reliable. The products remain safe and undamaged in our packaging. FeatureHeat Resistant BodyThe body of the tool is made from a special alloy steel that has high heat resistant properties.A special surface treatment is used to increase wear and corrosion resistance.2 Insert Bottom Cutting EdgeThe lower cutting edge consists of 2 inserts, resulting in higher cutting edge strength and increased tool life.One Insert TypeTool management is simplified by using only one type of insert for all 4 cutting edges. By rotating the inserts it’s possible to use all 4 corners.Center Cutting EdgeThe AQX is designed with a center cutting edge, making it possible to sink, helical mill and pocket without a pre-prepared hole.Through Coolant HolesThe body is designed with through coolant holes toã��improve cooling and chip disposal. The AQX is also available without coolant holes.Short Edge TypeAn economical short edge type body is available with only 2 inserts for short depth of cut applications. Undercut TypeThe cutting edge diameter DC has been designed so it is larger than the shank diameter DCON, making it possible to machine vertical faces without any interference.New PVD Coated Grades MP6100/MP7100/MP9100 Wide range of grades for specific materials MIRACLE SIGMA accumulated Al-Ti-Cr-N based PVD coating TOUGH-Σ Technology A fusion of the separate coating technologies; PVD and multi-layering realises extra toughness. Dramatically improving the heat and wear resistance! Excellent welding resistance due to low coefficient friction! Wide Range of Inserts M2 Breaker - Economical molded inserts. Suitable for machining a wide range of work materials under various cutting conditions. G1 Breaker - High accuracy peripherally ground inserts. Large rake angle to provide high cutting edge sharpness. An HTi10 insert is available with a polished rake face to prevent welding problems when machining aluminum alloys

GMP Model Multi-Mill is useful for various purposes like granulation, shredding, pulverization etc Capacity 200 kg/hr for Dry Granules 3.0 HP 440 volts Motor The rotor has 12 Nos. swinging type knife-blades and 2 Nos. scraper-blades All contact parts are made out of S.S. 316 quality and Body cladded with S.S. 304 sheet Speed Variation by AC Drive (optional)