Testing Equipment Dealers in Dabagardens, Visakhapatnam

• Certification: CE Certified, ISI Certified, ISO 9001:2008 Certified
• Color: Green, Grey, Light Green, Multicolor, Sky Blue, White
• Condition: New, Used
• Application: Control Panels, Industrial Use, Power Grade Use
• Frequency: 45Hz, 66Hz
• Power Source: Battery, Electric
• Feature: Easy To Use, Electrical Porcelain, Four Times Stronger, Proper Working, Superior Finish, Water Proof
• Warranty: 1year, 2years, 5years
• Operating Current: Double Phase, Single Phase, Triple Phase
• Temperature Capacity: High Temperature, Low Temperature, Medium Temperature
• Puncture Voltage: 11000V, 220V, 25000V, 33000V, 440V, 5000V, 580V

Asphalt/Bitumen Testing Lab Equipments Electrically Operated for determining the ductility of asphalt and bitumen. The ductility of bitumen is expressed as the distance in centimeters to which a standard briquette can be elongated before the thread thus formed breaks under specified conditions. The ductility testing machine is designed to test three specimens simultaneously, and consists of a bath thermostatically controlled with inlet and outlet taps and is equipped with an electric pump circulator & heater and carriage moving over a lead screw. Fixed and movable brackets are so positioned that specimen is submerged in water throughout. A clutch arrangement is made to stop the movement of the movable bracket when rapture of the specimen is noticed. An electric motor driven reduction gear unit ensures smooth constant speed and continuous operation and provides two rates of pull / travel, i.e., 50mm/min and 10 mm/min in the machine.

Pile integrity test is used to assess the continuity of piles. With this test, necking or bulging and uniformity of quality of concrete is checked.Piles that are doubtful for integrity are taken up for Dynamic load testing along with some piles which are ok. Method of Testing : There are Indian Standards for the pile integrity test & the most commonly used worldwide is Pile Integrity Test as per ASTM – D 5882 – 00, “Standard Test Method for Low Strain Integrity Testing of Piles”. Relevant clause from the said ASTM standard is reproduced below: Clause no. 5.2.3 : Placement of Transducers – The motion sensor should be placed at or near the pile head using a suitable, or temporary, bonding material (that is wax, vaseline etc.) so that it is assured that it correctly measures the axial pile motion. The motion sensor is placed generally near the center of pile. Additional locations should be consi...

paint testing instruments, boiler automation products

Digital Tds Meter, digital thermostat, metering units, Inside Micrometers

PVC, submersibles pump, Sanitary Ware, Water Tanks, gunmetal valves

Network Cable Tester, Tulsi Leaves, Electrical Toys, networking hardware

Testing Instruments, Electronic Instruments, high power ac systems

PVC, Bathroom Fittings, Cpvc Fittings, CPVC Pipes, flushing cistern

battery testers, Batteries, Battery Chargers